Parts for Kenmore 790.75902993 (79075902993, 790 75902993): Backguard Parts

Replacement owner's manual for your range. Provides operating instructions, maintenance guidelines, and safety information if original was lost or damaged.

Size: 8-18ab x 0.5 inch.

This 15-ounce grate cleaner removes grease, food residue, and burnt-on stains from your range's cooking grates. The four-pack provides enough cleaner for multiple thorough cleanings to restore your grates to like-new condition.

Size: 10-32 x 0.312 inch. Color: Black.

Burner won't turn off or element light stays on? This range burner control switch regulates temperature and power. Moderate DIY repair, 30-60 minutes.

Size: 10 fl. oz. Used on glass, ceramic and porcelain cooktops.

Signals when your range burners or oven are active. Replace when light fails to illuminate or stays on constantly. Confirm fit with your model number.

If your range displays error codes, won't heat, or has unresponsive buttons, the control board may need replacement. Moderate difficulty repair.

Replace your range's control knob if it's cracked, broken, or missing. This knob installs on the control panel to operate burners or oven settings.

Protects and diffuses your range's indicator light that signals when burners are on or surfaces are hot. Replace if cracked or missing. Easy install.

This replacement nameplate restores the front identification badge and cosmetic finish on the appliance, helping the unit look complete and factory-original again. It's a direct-fit exterior badge used where the original label has worn or fallen off. What it does:

• Replaces a missing, peeled, or faded exterior nameplate to restore the appliance's appearance.
• Serves as the decorative identification badge that mounts to the appliance surface.
• Helps prevent sharp edges or loose fragments from remaining after the old badge is removed.
• Useful when the original nameplate is cracked, scratched, or no longer adheres.

• One replacement nameplate

• High-level, safety-first: always unplug the appliance or disable power at the breaker before starting work near electrical components.
• Remove the old nameplate and any leftover adhesive or debris; clean and dry the mounting surface before installing the new badge.
• Align the new nameplate carefully and press firmly; handle with gloves to avoid fingerprints or cuts from edges.
• If fasteners or adhesive are required, use the OEM-specified method.

This clip is a small mounting retainer used to secure panels, trim, or wiring inside the refrigerator. It restores proper fit and reduces rattling or loose parts for a quieter, safer appliance. What it does

• Holds panels, trim pieces, or wiring harnesses in place to prevent sagging or separation
• Stops vibrations and rattling caused by loose components
• Prevents wiring from rubbing or catching on moving parts
• Helps maintain correct alignment of removable trim and access panels

• Inspect the mating surfaces for damage; replace any broken mating tabs before installing the clip
• Push the clip into the mounting hole until it snaps securely; verify the retained part is firmly seated
• Disconnect power to the appliance before working near electrical components
• Use hand tools only and avoid force that could break adjacent plastic parts