Parts for DEIX2-96105A: Base Panel Parts

This manual-reset thermostat is a temperature-sensing safety cutoff that interrupts power when temperatures rise above a set point, helping prevent overheating in the appliance. Replaces a tripped thermal cutoff so the unit can be tested and returned to service. What it does:

• Acts as a temperature-activated safety switch that opens when the sensor detects excessive heat
• Stops current flow to the affected circuit to help protect components from overheating
• Allows manual resetting after the unit has cooled and any underlying fault is fixed
• Commonly used where a single, resettable over-temperature protection device is required

• Disconnect power before replacing—electrical shock hazard
• Verify the cause of the over-temperature condition before resetting to avoid repeat trips
• Match wiring and mounting orientation to the original part for proper operation

The Thermostat Auto Reset is an OEM replacement part for Fisher & Paykel electric and gas dryers. Precisely located within heating circuits, it monitors internal air temperatures and automatically resets the thermostat when needed. 

Causes of a faulty reset thermostat can include:  

• Fluctuating or inconsistent vent temperatures   
• Frequent on-off cycling of gas valves or heating coils
• Triggering of drying error codes and safety shutoffs
• Inability to detect correct drying time end points

Symptoms involve temperature swings, premature shutoffs, and unfinished loads. Long term exposure to heat or combustion byproducts can degrade sensor function over time. 

The Safety Thermostat is an OEM part for Fisher & Paykel dryers. As an important safety device, the thermostat monitors the dryer drum temperature and automatically shuts off the dryer if temperatures become excessively high. It plays a protective role by preventing overheating that could pose a fire hazard.

Causes can be normal wear and tear over extended use.  
Symptoms of a bad safety thermostat include:

• The dryer failing to heat or heating unevenly
• Abnormal drying times as heat is improperly regulated
• Shut offs mid-cycle accompanied by flashing lights or error codes

The Dryer Leveling Leg is an OEM part for Fisher & Paykel dryers. It securely elevates and stabilizes the dryer unit on any floor surface. The leveling leg allows for balance, and level adjustment, and protects against moisture concerns.

Symptoms of an insufficient leveling leg include: 

• Dryer rocking or wobbling noticeably during operation
• Premature wear of internal tumbler bearings  
• Vents or doors failing to seal properly

Causes of a faulty leveling leg can be damaged from repositioning the heavy dryer on uneven flooring. Over time, repeated stress leads to fractures of mounting points. 

The Dryer Leveling Leg is an OEM part for Fisher & Paykel dryers. It securely elevates and stabilizes the dryer unit on any floor surface. The leveling leg allows for balance, and level adjustment, and protects against moisture concerns.

Symptoms of an insufficient leveling leg include: 

• Dryer rocking or wobbling noticeably during operation
• Premature wear of internal tumbler bearings  
• Vents or doors failing to seal properly

Causes of a faulty leveling leg can be damaged from repositioning the heavy dryer on uneven flooring. Over time, repeated stress leads to fractures of mounting points.