Parts for DEIX2-96105A: Cabinet / Drum / Inlet Duct Parts

The Safety Thermostat is an OEM part for Fisher & Paykel dryers. As an important safety device, the thermostat monitors the dryer drum temperature and automatically shuts off the dryer if temperatures become excessively high. It plays a protective role by preventing overheating that could pose a fire hazard.

Causes can be normal wear and tear over extended use.  
Symptoms of a bad safety thermostat include:

• The dryer failing to heat or heating unevenly
• Abnormal drying times as heat is improperly regulated
• Shut offs mid-cycle accompanied by flashing lights or error codes

The Thermostat Auto Reset is an OEM replacement part for Fisher & Paykel electric and gas dryers. Precisely located within heating circuits, it monitors internal air temperatures and automatically resets the thermostat when needed. 

Causes of a faulty reset thermostat can include:  

• Fluctuating or inconsistent vent temperatures   
• Frequent on-off cycling of gas valves or heating coils
• Triggering of drying error codes and safety shutoffs
• Inability to detect correct drying time end points

Symptoms involve temperature swings, premature shutoffs, and unfinished loads. Long term exposure to heat or combustion byproducts can degrade sensor function over time. 

This drum bearing kit replaces the rear support bearing that helps the dryer drum rotate smoothly. Restoring the bearing reduces noise and wobble for steadier, more reliable drum operation. What it does

• Supports the rear of the dryer drum so it turns freely
• Reduces grinding, squealing, or rumbling noises from the rear of the dryer
• Helps stop excessive drum wobble or uneven spinning
• Protects the drum and bulkhead from wear caused by a failed bearing

• Disconnect power to the dryer before any service to avoid shock or injury
• Access typically requires removing the dryer rear panel or drum; follow the OEM service instructions for your model
• Inspect drum seals, rollers, and the shaft for additional wear while installing the bearing
• Use appropriate tools and fasteners

This shield duct inlet directs dryer exhaust and protects the cabinet opening where the vent connects, helping maintain proper airflow and reduce lint intrusion. It restores a secure, sealed connection between the dryer and the vent duct. What it does:

• Guides exhaust airflow from the dryer into the external vent to help efficient venting
• Shields the cabinet opening to prevent lint and debris from entering internal components
• Helps reduce air leaks at the duct connection that can lower drying performance
• Stops rattling or loose duct connections by providing a stable mounting surface

• One shield duct inlet

• Disconnect power (and gas supply for gas dryers) before starting work
• Verify orientation and fit before fastening; replace any damaged fasteners or gaskets
• Reinstall panels and secure duct clamps/screws to ensure a tight seal
• Run a short test cycle and inspect the duct connection for leaks after installation