Parts for DEIX2-96105A: Top Deck And Electronics Parts

This is a stainless steel #8 x 5/8" Phillips screw sold in a pack of 10 — a direct-fit fastener for appliance panels, brackets, and trim. Durable corrosion resistance helps maintain secure assemblies over time. What it does:

• Fastens panels, brackets, trim pieces, and other appliance components using a Phillips driver
• Stainless finish resists rust and corrosion in humid or wet appliance areas
• Sized for common appliance mounting points where #8 x 5/8" screws are specified
• Helps restore loose or missing fasteners that cause rattling or poorly seated panels

• Ten (10) stainless steel #8 x 5/8" Phillips screws

• Use the correct #2 Phillips bit and moderate torque to avoid stripping the head or damaging mating parts
• Tighten until snug; do not overtighten plastic components
• Disconnect power to the appliance before accessing internal panels or wiring
• Keep loose screws away from children and dispose of packaging responsibly

This display module (DIX1) is the electronic front-panel used to show settings and status; it restores visible readouts so you can confirm cycle selection and operating information at a glance. What it does

• Replaces a failed or blank front-panel display to restore on-screen status and user feedback
• Helps address symptoms like missing numbers/letters, unlit display segments, or intermittent display output
• Interfaces with the appliance control board to show time, modes, and error indicators
• Useful when the glass/control fascia appears intact but the display itself is nonfunctional

• One display module (DIX1) as shown

• Disconnect power to the appliance before attempting replacement to avoid electrical shock
• Handle the display by the edges and avoid touching connector pins or circuitry
• Some installations require removing the control panel; keep screws and small parts organized for reassembly

The Lid Assembly is an OEM part for Fisher & Paykel dryers. It consists of the dryer lid and attached hinges, which provide controlled access to the drying chamber.

Symptoms of a bad lid assembly include:

• Difficulty opening or closing the dryer lid
• Loose, unstable, or off-track movement of the lid
• Gaps in the lid seal letting heated air escape

Causes of failure can be stripped or worn-out hinges, broken seals or cracked plastic over prolonged use. Overloading the dryer can also put excess stress on the lid assembly.

The Safety Thermostat is an OEM part for Fisher & Paykel dryers. As an important safety device, the thermostat monitors the dryer drum temperature and automatically shuts off the dryer if temperatures become excessively high. It plays a protective role by preventing overheating that could pose a fire hazard.

Causes can be normal wear and tear over extended use.  
Symptoms of a bad safety thermostat include:

• The dryer failing to heat or heating unevenly
• Abnormal drying times as heat is improperly regulated
• Shut offs mid-cycle accompanied by flashing lights or error codes

The Thermostat Auto Reset is an OEM replacement part for Fisher & Paykel electric and gas dryers. Precisely located within heating circuits, it monitors internal air temperatures and automatically resets the thermostat when needed. 

Causes of a faulty reset thermostat can include:  

• Fluctuating or inconsistent vent temperatures   
• Frequent on-off cycling of gas valves or heating coils
• Triggering of drying error codes and safety shutoffs
• Inability to detect correct drying time end points

Symptoms involve temperature swings, premature shutoffs, and unfinished loads. Long term exposure to heat or combustion byproducts can degrade sensor function over time.