Parts for Kitchenaid KSM3306QCA0: Base And Pedestal Unit Parts

This 8-32 x 5/8 screw replaces missing or damaged hardware specified by the manufacturer to secure panels, brackets, and internal components in your appliance. Restores a tight, rattle-free fit to help prevent vibration and misalignment.

• Provides the correct 8-32 thread and 5/8-inch length where specified
• Secures sheet-metal panels, brackets, and internal assemblies
• Replaces missing, stripped, or corroded screws
• Symptoms include loose or rattling panels, misaligned parts, or hardware that won't stay tight

• Disconnect power; shut off gas before servicing
• Support panels/components while removing or installing hardware
• Start threads by hand to avoid cross-threading; tighten only until snug
• Match the original screw's location and orientation for proper fit

The Foot is an OEM part for Whirlpool stand mixers. This component is designed to provide stability and support to the mixer, ensuring it remains steady during operation. Positioned at the base of the mixer, the foot helps to prevent movement and vibration, which can enhance the efficiency of mixing and protect your countertop from scratches.

Symptoms of a failing Foot include:

• The mixer wobbling or moving excessively during use
• Increased noise or vibration when the mixer is running
• Visible wear, cracks, or deformation of the foot pad
• Scratches or damage to the countertop surface beneath the mixer

Causes of a bad foot can include prolonged use that wears down the material, exposure to heat or kitchen chemicals that degrade the foot, or physical damage from moving or storing the mixer.

This OEM Whirlpool part is also compatible with KitchenAid stand mixers.

The Idler Shaft Retaining Ring is an OEM replacement part for Whirlpool dryers. Also called an "E" ring, it is a sealing gasket positioned between the front and rear housing omponents. Maintaining an airtight seal prevents gas leakage and promotes efficient drying performance.  

Causes of a bad retaining ring commonly involve compression loss of the rubber gasket material over many years of heating cycles. Exposure to petroleum-based cleaners may prematurely deteriorate the seal as well.

Symptoms of a failed 'E' ring include: 

• Gas leaks emitting foul odors around seams or vents   
• Reduced heat conductivity hampering dryer functioning
• Moisture accumulation shortens fabric lifespan  
•  Drafts compromising indoor air quality and energy bills

This OEM Whirlpool replacement part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore gas dryer models. 

This replacement mixer bowl restores a damaged or missing mixing bowl so your stand mixer can hold ingredients securely for everyday mixing tasks. It provides a direct-fit bowl option to resume normal food preparation. What it does:

• Holds ingredients for mixing, beating, and folding
• Replaces cracked, dented, or missing bowls that cause leaks or instability
• Restores proper bowl engagement with the mixer's drive and attachments
• Helps prevent food contamination from damaged bowl surfaces

• One replacement mixer bowl (single bowl only)

• Turn power off and disconnect the mixer before removing or installing the bowl
• Align bowl with the mixer's support and locking mechanism; rotate into place until secure
• Inspect for chips or sharp edges before use; do not use a damaged bowl
• Use manufacturer-recommended cleaning methods; avoid abrasive cleaners that can damage the finish

Flex Edge Beater is used with 3.5 Quart KitchenAid Tilt Head Stand Mixers. The Flex Edge Beater is designed to reduce mixing time when mixing with this beater. The beater features a flexible edge that thoroughly scrapes ingredients from the sides of the bowl and fits KitchenAid Stand Mixer models KSM3311 and KSM3316.

This 6 Wire Whip incorporates air into ingredients for fluffy whipped cream, perfect for frostings and cakes with whipped egg whites. Fits KitchenAid 3.5 Quart Tilt Head models KSM3306, KSM3311, KSM3316, KSM3317, 5KSM3310, 5KSM3311, 7KSM3311, 9KSM3311.

This Coated C-Dough Hook mixes and kneads yeast dough with ease, saving you both the time and effort of hand kneading. The dough hook is top-rack dishwasher safe. Fits models KSM3306, KSM3311, KSM3316, KSM3317, 5KSM3310, 5KSM3311, 7KSM3311, 9KSM3311.