Bosch Range / Cooktop / Oven Parts

Supports the burner assembly and positions the cap for consistent flame distribution. Replace if damaged, warped, or causing burner misalignment.

Jet holder assembly routes gas through the orifice to the burner. Replace if cracked, corroded, or stripped threads prevent secure installation.

Replacement control knob for cooktop burners. Restores heat setting adjustments when original knob is cracked, stripped, or missing. Installs on control shaft.

Secures the burner orifice in position to deliver the correct gas jet size for your 12,500 BTU natural gas burner. Replace if cracked, broken, or missing.

This replacement cooking-area knob restores user control to a range or cooktop, providing a secure grip and clear position changes for accurate heat selection. Durable plastic construction matches original fit and feel. What it does:

• Replaces a worn, cracked, or missing cooking-area control knob so temperature settings can be selected reliably
• Engages the stove's control shaft to turn burners or elements on and off
• Helps prevent accidental slips or mis-selections with a firm, indexed grip
• Common symptom fix: knob won't turn, is loose, or stops responding

• One replacement cooking-area control knob

• Turn power/gas to the appliance off and allow surfaces to cool before servicing
• Pull the old knob straight off the control shaft and push the new knob fully onto the shaft until seated
• If knob does not seat, verify shaft type and knob orientation; do not force to avoid damage

This burner base supports the cooktop's burner cap and directs flame for even heating. It replaces a damaged or warped base to restore stable burner alignment and consistent flame pattern. What it does:

• Holds the burner cap in place and centers the gas flame
• Channels gas flow for proper burner operation
• Helps prevent wobbling or uneven heating from a warped base
• Commonly replaced when the base is cracked, corroded, or bent

• One burner base (B)

• Turn off gas supply and power to the appliance before servicing
• Remove surrounding burner components and reassemble in reverse order
• Inspect nearby seals and burner ports for damage; replace if necessary

Pressure regulator for gas cooktops maintains consistent gas flow to burners. Replace if leaking gas odor, damaged vent, or worn seals detected.

Replace worn cooktop burner gasket seals to prevent gas leaks and ensure proper flame control. Verify compatibility with your model number before ordering.

Secures 6mm shafts and spindles on cooktop burners and controls. Replace if parts slip or wobble during use. Confirm 6mm shaft size before ordering.

Mounting bracket that secures double burner assemblies to your gas cooktop frame. Replace if cracked, bent, or missing to properly support burner units.

Microwave door won't close or latch properly? This door latch assembly secures the door during operation, allowing cycles to start and run safely.

Used to hold down the jet holder assembly.

Fix uneven baking or slow preheating in your wall oven. This convection fan motor restores proper air circulation for consistent cooking results.