Parts for Huebsch 37CE: Burner Assembly Parts

This replacement igniter is the glow-style heating element that lights the gas burner in compatible gas dryers, restoring reliable ignition so the dryer can produce heat when calling for a cycle. What it does

• Heats to a glowing temperature to ignite burner gas when the dryer starts
• Replaces a cracked, broken, or non-glowing igniter that prevents the burner from lighting
• Common symptom: dryer runs but does not produce heat
• Also used when the igniter shows visible damage or fails continuity checks

• One igniter (glow bar)

• Disconnect electrical power and shut off gas supply before servicing
• Handle the ceramic/element carefully; the glow element is fragile and can break if touched or dropped
• Follow OEM service instructions and replace any suspect mounting hardware or sensors encountered during replacement

This sensor monitors operating conditions and relays accurate feedback to the control so cycles run properly. Replacing a failed sensor helps restore correct operation and prevent erratic behavior or fault codes. What it does:

• Detects a specific operating condition and sends a signal to the control
• Helps the machine regulate cycle timing and performance
• Can cause error codes, cycles that won't start or advance, or intermittent shutdowns when failing
• Lead to inconsistent temperatures or sensing behavior depending on application

• 1 sensor

• Disconnect power (and shut off gas/water, if applicable) before servicing
• Access the sensor; note wire positions and connector orientation
• Install the new sensor in the same location and orientation; seat connectors fully
• Clear any stored faults and run a test cycle per the tech sheet

A replacement timing cam that positions the timer/timer shaft to control cycle sequencing in compatible Speed Queen washers, helping the machine advance reliably through agitation, drain and spin stages for consistent operation. What it does:

• Rotates with the timer to index cycle steps, enabling proper engagement of transmission/clutch and water/drain functions
• Common repair part when a washer won't advance between cycles, gets stuck on a single stage, or skips spin/agitate
• Ensures correct mechanical timing for cycle transitions when installed and aligned correctly
• Typical molded cam design built to match OEM timing profiles for reliable fit

• Disconnect power and follow OEM service procedures before removing the console or timer assembly
• Observe alignment marks and index position on the timer shaft during removal and installation
• Replace only with the exact part number to ensure proper fit
• Do not attempt electrical testing while the unit is powered