Parts for Huebsch 37CE: Gas Heater Assembly (Glow-Bar Ignition) Parts

Dryer not heating or overheating? This thermostat cover protects the temperature sensor. Quick 15-minute fix restores proper heat regulation.

Dryer won't start or shuts off too soon? This high limit thermostat prevents overheating by cutting power when temps get too high. Easy 20-min fix.

This sensor monitors operating conditions and relays accurate feedback to the control so cycles run properly. Replacing a failed sensor helps restore correct operation and prevent erratic behavior or fault codes. What it does:

• Detects a specific operating condition and sends a signal to the control
• Helps the machine regulate cycle timing and performance
• Can cause error codes, cycles that won't start or advance, or intermittent shutdowns when failing
• Lead to inconsistent temperatures or sensing behavior depending on application

• 1 sensor

• Disconnect power (and shut off gas/water, if applicable) before servicing
• Access the sensor; note wire positions and connector orientation
• Install the new sensor in the same location and orientation; seat connectors fully
• Clear any stored faults and run a test cycle per the tech sheet

This replacement igniter is the glow-style heating element that lights the gas burner in compatible gas dryers, restoring reliable ignition so the dryer can produce heat when calling for a cycle. What it does

• Heats to a glowing temperature to ignite burner gas when the dryer starts
• Replaces a cracked, broken, or non-glowing igniter that prevents the burner from lighting
• Common symptom: dryer runs but does not produce heat
• Also used when the igniter shows visible damage or fails continuity checks

• One igniter (glow bar)

• Disconnect electrical power and shut off gas supply before servicing
• Handle the ceramic/element carefully; the glow element is fragile and can break if touched or dropped
• Follow OEM service instructions and replace any suspect mounting hardware or sensors encountered during replacement

Fix a dryer that won't heat or heats poorly with this burner assembly kit. Includes essential components for gas dryer ignition system repair.

Fix a dryer that won't advance through cycles properly with this timing cam. Restores automatic cycle progression. Moderate difficulty repair.

Fix a dryer that won't advance through cycles with this timing cam. Positions the timer shaft to control sequencing through all cycle stages.