Parts for Kenmore 110.9875279A (1109875279A, 110 9875279A): Burner Assembly Parts

This water inlet valve assembly controls water flow to the refrigerator's dispenser and ice maker, restoring reliable water delivery and stopping leaks or no-water issues when the original valve fails. What it does:

• Opens and closes to supply water to the ice maker and door dispenser
• Allows proper water pressure for filling ice maker trays and dispensing
• Stops water flow when closed to prevent leaks or overfilling
• Faulty valves can cause no water from dispenser, slow fill, continuous running, or leaks

• One water inlet valve assembly

• Disconnect power and shut off the water supply before service
• Verify fittings and tubing are seated and tightened to avoid leaks
• Replace only with matching part number and test for leaks after restoring water/power

Gas burner orifice for dryers. Installs in the burner assembly to regulate gas flow. Replace if damaged, corroded, or missing for proper operation.

Wire harness for dryers. Replaces damaged, frayed, or burnt wiring harnesses. Essential when original wiring is cracked, melted, or connections worn.

Dryer won't heat or flame shuts off after seconds? Gas valve coils control gas flow to the burner. Common fix, typically completed in 15-30 minutes.

Dryer not heating or won't dry clothes? This igniter kit lights the gas burner. Moderately easy DIY repair with video guide—replaces failed igniters.

Replacement mounting screw for securing panels, brackets, and interior assemblies. Needed when original screw is stripped, missing, or damaged.

The Flame Sensor is an OEM replacement part for Whirlpool gas dryers. This component plays a critical safety role by monitoring the presence of the gas burner flame during the drying cycle.

Causes of needing to replace the flame sensor can include normal wear and tear over extended use, exposure to high temperatures or corrosion, or physical damage to the sensor itself.

Symptoms that may indicate a faulty flame sensor include:

• The dryer not heating or producing heat properly
• Error codes related to the gas system or ignition failure
• The dryer shutting off unexpectedly during cycles

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore gas dryer models. 

This part has been discontinued and is no longer available.

This pipe plug seals an unused or service opening in a household appliance's plumbing to stop leaks and prevent debris entry. It restores a watertight closure so the appliance can operate safely and without water loss. What it does:

• Plugs open pipe or hose fittings to prevent water leaks
• Helps maintain proper water flow by sealing unused ports
• Keeps debris and contaminants out of the plumbing system
• Can stop intermittent drips originating from service openings

• One pipe plug

• Turn off water supply and power to the appliance before starting work
• Hand-start threads to avoid cross-threading; tighten only to OEM torque or finger-tight plus a quarter-turn if unspecified
• If the original used sealant or gasket, replace with the same type per OEM instructions

This LP gas conversion orifice adjusts gas flow for compatible gas ranges and cooktops when converting from natural gas to liquid propane, helping the appliance run safely and correctly after conversion. What it does:

• Replaces the burner orifice to reduce gas flow for LP fuel pressure and correct flame size
• Helps restore consistent, stable burner flames after an authorized LP conversion
• Addresses symptoms like unusually large or yellow flames, poor ignition, or unstable burner performance after conversion
• Works with the appliance's existing valve and burner components as part of a proper conversion

• Follow the appliance manufacturer's LP conversion instructions and parts list exactly
• Turn off gas supply and disconnect power before servicing
• Use correct torque and fittings; do not force or cross-thread the orifice
• Always perform an approved gas leak test and check burner flames after installation