Parts for Ge WSM2780DBWWW: 04 - Cabinet & Top Panel Parts

8 - 18 x 0.31

This pad level leg is the replacement leveling foot that supports and stabilizes the appliance, letting you adjust height and help eliminate rocking or uneven operation for a more secure, balanced installation. What it does

• Raises or lowers the appliance to level on uneven floors
• Dampens vibration and reduces rocking or movement during cycles
• Helps improve door/lid alignment and seal by stabilizing the cabinet
• Common symptom: appliance wobbles, tips, or shifts during use

• One pad level leg

• Turn off and unplug the appliance before making adjustments or repairs
• Adjust by rotating the leg; ensure all legs contact the floor for stability
• Use a helper or support the appliance when lifting a corner to change the leg
• If original hardware is damaged or missing, replace with matching OEM fasteners

This right-side bracket joiner secures and aligns cabinet or drawer panels where specified by the manufacturer, restoring proper fit and stability. Designed to replace a damaged or missing joiner and help maintain smooth door/drawer operation. What it does:

• Connects and reinforces the right-side joint between adjacent panels or components
• Restores alignment to reduce rubbing, gaps, or sticking during use
• Provides a secure mounting point for adjacent trim or hardware
• Helps maintain proper structural fit after impact or wear

• One right-side bracket joiner

• Use basic hand tools; disconnect power to affected appliance if removing any electrical panels
• Retain original fasteners when possible; replace damaged hardware with equivalent parts
• Inspect surrounding mounting surfaces for damage and clean before installing

A small locating pin used to secure and align components during assembly for proper fit and operation. Replaces a worn or missing locating pin to restore correct part positioning and reduce misalignment-related issues. What it does:

• Aligns mating parts during assembly to ensure correct positioning and operation
• Holds components in place to prevent shifting or vibration-related noise
• Helps maintain consistent clearances for moving parts
• Commonly replaced when the original pin is bent, broken, or missing

• One locating pin

• Disconnect power to the appliance before beginning any repair
• Inspect surrounding components for wear or damage when replacing the pin
• Install by aligning parts and pressing the pin into its mating hole until fully seated
• If the pin is press-fit, use appropriate tools (press or mallet with a block) to avoid damage

A replacement pan head screw used to fasten appliance panels and components. Its standard #8 coarse thread and 3/8-inch length secure trim, brackets, and small assemblies for stable operation. What it does:

• Fastens panels, brackets, and small parts in household appliances
• Replaces stripped, rusted, or missing #8-18 pan head screws
• Restores secure mounting where vibration or wear caused looseness
• Works with sheet-metal or threaded inserts designed for #8-18 screws

• Disconnect power to the appliance before beginning any repair
• Use the correct #2 Phillips or compatible driver to avoid cam-out
• Thread in straight and tighten until snug; avoid over-tightening to prevent stripping
• Keep small screws away from children and dispose of old fasteners safely