Parts for Ge PFSS9SKYBSS: 08 - Case Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

Stainless steel top table assembly for refrigerators. Replaces cracked, damaged, or worn table surfaces. Installs on top of refrigerator cabinet.

This top table cap is a stainless-steel trim piece that covers and protects the front edge of the cooktop/top table. It restores a clean, finished appearance and helps keep grease and debris out of seams and fasteners. What it does:

• Replaces damaged or dented top-table front cap that shows visible wear
• Protects the cooktop edge and underlying components from spills and debris
• Restores proper fit and appearance after collision, corrosion, or removal
• Helps prevent snagging on the cooktop edge while loading cookware

• One stainless-steel top-table/front cap

• Basic trim replacement; typically held by clips or screws—inspect fasteners before removal
• Use care removing old trim to avoid scratching adjacent surfaces
• Disconnect power to ranges with electronic controls before working nearby as a safety precaution
• If corrosion or underlying damage is present, address those areas before installing the new cap

A small metal C-shaped retaining clip that secures shafts, pins or components in place to prevent unwanted movement. Simple, durable hardware that restores proper fit and alignment for the part it secures. What it does:

• Holds shafts, pins or rods in position to prevent axial movement or disengagement
• Restores secure attachment where a worn or missing clip allows parts to shift or fall out
• Used in moving assemblies to maintain alignment and proper function
• Fits in a groove or slot and provides spring tension for a tight hold

• One C-clip (retaining clip)

• Inspect the mating groove/pin for burrs or damage before installing the clip
• Use appropriate snap-ring or pliers to compress/expand the clip as needed; wear eye protection
• Ensure the clip fully seats in its groove and that the retained component moves as intended

Auto close lever assembly for refrigerator doors. Installs on the hinge mechanism to ensure smooth automatic door closing. Replace if broken or worn.

Lever grommet for refrigerator door or dispenser assemblies. Replaces worn, cracked, or missing grommets that cause loose or rattling levers.

Replacement axle shaft that secures the drum roller wheel in your refrigerator. Needed when the original shaft is bent, broken, or worn, causing wheel misalignment.

Water supply line assembly that connects to the filter head in your refrigerator. Replace if cracked, leaking, or damaged to restore proper water flow.

This service wrench is a replacement hand tool used to loosen and tighten appliance fasteners during repairs, making component removal and reassembly easier and more reliable for technicians and DIYers. What it does:

• Provides the correct fit and leverage for specific appliance fasteners to prevent rounding or damage
• Helps remove and install parts that are secured with hard-to-reach or tight fasteners
• Useful when a loose or seized fastener prevents normal appliance operation or maintenance
• Designed for repair tasks where the original tool is lost or worn

• Disconnect power and gas before starting any repair
• Use appropriate personal protective equipment; avoid excessive force to prevent tool or fastener damage
• Follow manufacturer instructions for the specific repair task
• Keep removed fasteners and small parts in a safe container to avoid loss

Rubber grommet that cushions and secures the door/light switch assembly in your refrigerator. Replace when worn, missing, or cracked to restore fit.