Central Park Parts

This genuine OEM part is a compression spring for a lawnmower. The compression spring is the spring that holds the mower deck onto the lawnmower. Over time, the compression spring can become degraded due to excessive wear and tear. If it is no longer securing the mower deck, it will need to be replaced. Luckily, replacing this part is a relatively simple process.To replace the spring, make sure the mower deck is set to the lowest position. Locate the old retainer spring and pull it out and away from the mower. Once removed, slide the new spring into its proper position. Make sure it fits tightly, and the mower deck is secured. Once secured, power the mower to see if the spring stays in place during operation. If it does, then the installation was a success. This replacement part is sold individually and is compatible with MTD brand lawnmowers.

Small metal washer that installs with screws and bolts throughout lawn mowers and outdoor power equipment. Replace if cracked, worn, or missing.

Flat washer for lawn tractors and mowers. Replace when worn, damaged, or lost to ensure proper hardware fit and secure assembly. Verify compatibility.

Small metal washer for lawn mowers and outdoor power equipment. Replaces cracked, worn, or missing washers. Ensures proper spacing and assembly.

Shoulder screw fastener for lawn tractor internal machinery. Replace if screw is stripped, missing, or no longer secures components properly.

This is a thrust bearing. The thrust bearing is positioned between the lawn mower's spindle and front axle and serves to reduce friction during use. This part makes shifting between different speeds much easier. A worn-out thrust bearing will have more room between the rollers on the outside of the bearing. This movement will cause the bearing to move more than usual. When the bearing goes bad, the driver may notice rattling, squeaking, or other noises coming from the machine. These noises can be more prevalent when the clutch pedal is engaged. To replace the thrust bearing, first, the clutch must be removed from the lawn mower. On the bottom of the driveshaft, there is a bolt and washer that need to be removed. Wedge and move the clutch, allowing it to work its way down the driveshaft, then remove it. There is a bearing retainer clip and three bolts that will enable the thrust bearing to be removed. Repeat the steps in reverse after installing the new component.This product is a genuine OEM MTD part sourced directly from the manufacturer. The part is sold individually and not available with any other components. This product is compatible with MTD and Cub Cadet products.

Spacer component for lawn mowers and tillers. Reduces friction between parts while maintaining proper spacing. Replace if worn, damaged, or missing.

Gas gauge not showing fuel level or stuck on your riding mower? This replacement gauge restores accurate fuel monitoring. Simple installation.

Fixes weak or no braking on lawn tractors and riding mowers. This brake disc restores stopping power when brakes drag, squeal, or fail to engage properly.

Deflector guard for lawn mower discharge chute. Directs grass clippings away from user. Replace if cracked, broken, or missing for safe operation.

Bowed washer for lawn mowers and tractors. Installs in fastening mechanisms to reduce friction. Replace if worn, damaged, or missing from assembly.

This replacement part is a casing clamp. It is a genuine replacement part made by MTD. This part is typically used to secure the governor control plate to the tank assembly.A new casing clamp might be needed if the current one is damaged or missing. Be sure the machine is stationary and the engine is completely powered down before beginning this repair. This part is made of durable metal so that it works properly with the machine at hand. Refer to the owner's guide for more information on this part. This air cleaner is a genuine OEM replacement part. This part is sold individually and is sourced directly from the manufacturer to ensure a proper fit.