Parts for Kitchenaid KUCV02FRSS1: 04 - Container Parts

This stainless container panel replaces a damaged or worn front for the refrigerator's storage container, restoring the compartment's appearance and helping the drawer close cleanly. It matches OEM fit and finish for a factory look. What it does:

• Replaces a scratched, dented, or corroded container/front panel
• Restores the drawer/container appearance and front edge alignment
• Helps the drawer seal and slide as intended when the front is intact
• Fits into the existing container assembly and uses factory mounting points

• One stainless container panel

• Requires basic disassembly of the container/drawer; keep fasteners and clips organized
• Inspect mating edges and clips for damage; replace any broken hardware separately
• Disconnect power only if working near electrical components; follow appliance-specific service manual

Replacement drawer container for trash compactors. Installs as the main compartment to hold contents securely. Needed when original is cracked, broken, or deformed.

Replace worn, stripped, or missing 8-18 x 3/8 machine screws that secure control panels, trim pieces, and brackets on your appliance. Restores tight fit.

Fix a stuck or difficult-to-open compactor drawer with this replacement foot pedal. Restores hands-free drawer release and smooth latch operation.

Size: 8-32 x 3/8 inch.

This door lock latch assembly secures the washer door during operation so cycles can run safely and water stays contained. It replaces a worn or damaged latch to restore proper door locking and cycle start. What it does

• Secures and locks the was

Compactor won't run unless you hold the dial? A worn safety switch actuator prevents proper door latch engagement. This repair restores automatic operation.

Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.

Replacement roller bearing for trash compactor drawers. Installs on tracks to support smooth gliding. Replace worn or damaged bearings for easier operation.

Size: 3\8-24 inch.

Front guard plate for trash compactors. Protects the compactor front panel from damage. Replace if cracked, torn, or worn to restore appearance.

This latch pin secures the door latch mechanism on your trash compactor. Replace if the pin is broken, worn, or missing to restore proper door latching.

Latch spring for trash compactors. Installs in the door latch mechanism to provide tension. Replace if cracked, broken, or missing to restore proper latch function.

Compactor door won't latch or latch feels loose? This E-ring retaining clip secures latch components to the shaft. Quick 5-minute fix for latch problems.

Door strike plate for trash compactors. Mounts to cabinet frame to secure the door latch. Replace if cracked, bent, or missing to restore proper closure.

Sheet metal pan head screw secures panels, brackets, and components to appliance cabinets. Replace missing, stripped, or corroded screws to restore fit.

Fits 15 and 18 inch compactors. This kit is for securing the compactor bags. Kit contains a set of 4 buttons and screws.

Fix a compactor that won't start when the door closes. This actuator switch kit includes a redesigned, more durable switch. DIY install in 30-60 minutes.