Parts for Huebsch 65CG: Control Panel Assembly (Manual) Parts

This replacement drive motor restores agitation and spin to compatible top-load commercial washers, bringing laundry cycles back to normal operation. Designed as a direct swap for failed or worn motors to get machines moving again. What it does

• Turns the transmission/drum to enable agitation and spin cycles.
• Replaces a motor that hums, stalls, or fails to start.
• Helps stop symptoms like no agitation, no spin, or intermittent operation.
• Restores normal wash and drain motion when the motor is the cause.

• Disconnect power before servicing and verify the washer is fully de-energized.
• Motor is heavy and may require two people or a hoist for safe removal/installation.
• Basic hand tools and access to the motor mounting and wiring are required; keep wire ID or photos for correct reconnection.

Control panel retainer for dryers. Secures the control panel assembly in place. Replace if cracked, broken, or missing to properly mount the panel.

Retainer secures the control panel to your dryer's front panel. Replace if the original is cracked, broken, or missing to properly mount the control panel.

This round-head bolt with a square neck secures sheet-metal panels and mounted components on laundry equipment. It provides a durable, low-profile fastener that resists turning once seated for reliable assemblies. What it does:

• Fastens panels, brackets or components where a square-neck bolt prevents rotation in a slotted or keyed hole.
• Keeps covers and assemblies tight to reduce vibration and rattling.
• Use when a low-profile, round head is required for clearance or cosmetic fit.
• Replacement for worn, stripped, or missing bolts that cause loose parts or intermittent noise.

• One round-head bolt with square neck, 3/8" diameter x 1" length.

• Replace with the same size and square-neck style to ensure proper fit and anti-rotation function.
• Hand-start the bolt, then tighten with the appropriate wrench; avoid over-tightening which can strip threads or deform parts.
• Disconnect power and follow appliance-specific safety steps before servicing panels or internal components.
• Wear eye protection and use proper hand tools; secure adjacent parts to prevent injury during reassembly.

Pop rivet with dome head for dryer panel and component assembly. Replace missing, stripped, or broken rivets during repairs or part installations.

Control knob for dryer cycle or temperature selection. Replaces worn, cracked, broken, or missing knobs on control panel. Direct replacement part.

Fix a dryer that won't advance through cycles properly with this timing cam. Restores automatic cycle progression. Moderate difficulty repair.

Fix a dryer that won't advance through cycles with this timing cam. Positions the timer shaft to control sequencing through all cycle stages.