Parts for Huebsch 65CG: Loading Door And Switch Rod Assembly Parts

This 10-32 hex-washer-head machine screw secures panels and components on commercial laundry equipment for reliable fit and alignment. It's a direct-fit fastener used where a small, strong screw is required. What it does:

• Fastens panels, brackets, and internal components where a 10-32 threaded screw is specified
• Provides a low-profile, wide-bearing hex washer head to resist pull-through
• Restores secure mounting when factory screws are missing, loose, or worn
• Helps stop rattling or misalignment caused by loose fasteners

• One machine screw (hex washer head, 10-32)

• Disconnect power to the appliance before accessing internal panels or components
• Use the correct 10-32 driver (hex head/socket) and avoid damaging the head
• Tighten to a snug fit; do not overtighten to avoid stripping threads or damaging parts
• Replace with the same size and head style to maintain proper fit and function

This 10-32 UNF hex nut provides a compact, threaded fastening solution for securing appliance panels and components. Zinc plating helps resist corrosion and keeps fasteners tight under normal operating conditions. What it does:

• Secures 10-32 machine screws and studs used on appliance assemblies
• Helps prevent panels, brackets, or small components from coming loose
• Restores proper fastening where a nut is missing, stripped, or damaged
• Simple replacement part for addressing loose or rattling trim and hardware

• Start threads by hand to avoid cross-threading, then tighten with the correct-size wrench or socket
• Do not overtighten; snug to manufacturer torque or until secure to avoid stripping threads
• Disconnect power or follow appliance safety procedures before servicing electrical components
• Replace any matching washers or mating hardware if worn or damaged

A replacement timing cam that positions the timer/timer shaft to control cycle sequencing in compatible Speed Queen washers, helping the machine advance reliably through agitation, drain and spin stages for consistent operation. What it does:

• Rotates with the timer to index cycle steps, enabling proper engagement of transmission/clutch and water/drain functions
• Common repair part when a washer won't advance between cycles, gets stuck on a single stage, or skips spin/agitate
• Ensures correct mechanical timing for cycle transitions when installed and aligned correctly
• Typical molded cam design built to match OEM timing profiles for reliable fit

• Disconnect power and follow OEM service procedures before removing the console or timer assembly
• Observe alignment marks and index position on the timer shaft during removal and installation
• Replace only with the exact part number to ensure proper fit
• Do not attempt electrical testing while the unit is powered