Parts for Ge JGB428SER2SS: 02 - Control Panel & Cooktop Parts

This end support holds the dryer drum in place and provides a stable mounting point for the drum shaft, helping the drum spin smoothly. Replaces a worn or broken support to reduce noise and drum wobble. What it does:

• Supports the drum shaft at the rear of the dryer for proper alignment
• Helps maintain smooth drum rotation and belt tracking
• Can reduce scraping, grinding or thumping noises caused by a damaged support
• Prevents excessive drum movement that can wear belts or other components

• Disconnect power to the appliance before beginning any repair
• Remove the dryer front or rear access panels to access the drum and support
• Note the support orientation and any mounting clips or screws; reinstall in the same position
• Inspect the drum shaft, glides and belt for wear while replacing the support

Replace your range's cracked or missing endcap with this structural trim piece. Installs at the end of the control panel or cooktop edge for a finished look.

Replace a cracked, faded, or worn control panel touch pad on your gas range. This overlay covers the control interface and restores a clean appearance.

Replace the upper back cover panel on your range. This housing component protects internal parts and completes the exterior. Order now if damaged or missing.

Lower back cover panel for gas ranges. Protects internal components at the rear base. Replace if cracked, damaged, or missing to restore appearance.

Secures components to your appliance chassis for a rattle-free fit. Replace missing, stripped, or corroded screws to keep panels and brackets aligned.

Burner won't light or no ticking sound from igniters? This spark module generates the spark that ignites gas burners. Moderate DIY repair, 30-45 minutes.

Harness connects spark module to burner igniters on gas ranges. Replace if wires are frayed, cracked, burned, or damaged to restore reliable ignition.

Pin locator for gas ranges. Secures and aligns burner components in proper position. Replace if broken, missing, or worn to restore proper burner assembly.

Black overlay that adheres to your range control panel. Replace if cracked, damaged, or worn. Peel-and-stick installation over the control board.

Burner base that sits beneath the burner cap on your cooktop. Replace this component if damaged, cracked, or missing to restore your burner's appearance.

Burner base for gas cooktops, secures to cooktop surface and holds igniter assembly. Replace if cracked, broken, or damaged during repairs.

Burner base installs beneath the burner cap on gas cooktops. Replace if cracked, warped, or dome-shaped to restore proper flame coverage and alignment.

Large burner base for cooktop. Installs beneath the burner cap to distribute heat evenly. Replace if cracked, warped, or corroded for proper burner function.

Approx 3 inches in diameter

Approx 2 inches in diameter

Note: The part is approximately 4" in diameter.

Approx 2-3/4 inches in diameter

Approx 3-1/4 inches in diameter

Left-side burner cap that centers and protects the burner head while shaping the flame. Replace if cracked, chipped, or worn to restore proper coverage.

Seals the cooktop to your range, preventing spills from entering the burner area. Replace if cracked, worn, or leaking. Verify fit with your model number.

Approx 4-1/4 inches in diameter

Color: Graphite for Stainless models.

Burner base that sits beneath the burner cap on your cooktop. Replace this component if damaged, cracked, or missing to restore your burner's appearance.

Aluminum washer for range installation and assembly. Replaces worn, missing, or damaged washers in your range. Essential hardware component.

Seals and cushions the edge of your range's glass or ceramic cooktop to keep out spills and reduce vibration. Replace if worn or damaged. Confirm fit.

Package of 12

Replacement mounting screw secures panels, brackets, and trim on ranges and cooktops. Install to replace missing, stripped, or rusted fasteners.