Parts for Ge PP9830DJ1BB: Control Panel & Cooktop Parts

If your electric cooktop burner won't adjust temperature or stays on one heat level, this infinite switch restores variable heat control for safe cooking.

Burner stuck on high or won't heat? This infinite switch controls surface element temperature from low to high. Straightforward repair restores heat control.

Wire guard for cooktop burner assembly. Protects wiring and components from heat damage. Replace if bent, broken, or missing for proper protection.

Replace a worn, cracked, or missing surface burner control knob on your electric cooktop. This black knob presses onto the element switch shaft for control.

Cooktop element not heating or stuck on? This infinite switch controls surface element temperature. Direct replacement part for electric cooktops.

Replace your cooktop indicator light lens when cracked, discolored, or dim. Restores visibility of heating element status. Confirm fit with your model.

Replace your cooktop indicator light lens when cracked, discolored, or dim. Restores visibility of burner status lights. Verify fit with your model number.

Downdraft fan not working? This fan switch activates the ventilation system. Moderately difficult repair—requires lifting cooktop to access mounting plate.

Replace your cooktop's selector knob if cracked, broken, or missing. This glossy black control knob installs on the control panel to operate settings.

This wire cover protects the terminal wiring on a radiant cooktop element, helping keep connections insulated and routed away from heat and sharp edges for safer, more reliable operation. What it does:

• Shields and insulates element terminal wires from heat and abrasion
• Keeps wires routed securely to reduce strain and prevent loose connections
• Helps prevent shorting or arcing caused by exposed or chafed wiring
• Commonly replaced when wiring is burned, cracked, or displaced
• Supports stable operation of the radiant surface element

• Always disconnect power at the breaker before accessing the cooktop or element
• Handle the glass cooktop and terminals carefully to avoid cracks or injury
• Slide the cover into place over the element terminals and verify wires are fully seated and routed away from hot surfaces
• If terminals, wires, or the cover show heat damage, replace the damaged components rather than reusing them

Wire junction box housing for cooktops. Protects electrical connections beneath the cooking surface. Replace if cracked, damaged, or missing.

If your cooktop makes a buzzing noise or won't turn on, this buzzer may need replacement. Compatible with select GE radiant and halogen cooktops.

Burner won't heat or heats unevenly? This 6 inch radiant element restores consistent cooking performance. Typical DIY repair takes 30-45 minutes.

Broken element not heating? This radiant bridge connector restores electrical contact between your cooktop element and wiring. Takes 10-15 minutes to install.

Burner won't heat or only inner ring works? This dual radiant element restores both heating zones on your cooktop. Moderate DIY with basic tools.

Heater spring for electric cooktops. Secures heating element in place. Replace if spring is broken, stretched, or missing to properly mount the element.

Foam seal tape creates an airtight barrier between your cooktop and countertop, preventing spills from dripping into cabinets. Replace when worn or gaps appear.

Installation kit for cooktops. Includes hardware and components needed to properly mount and secure your cooktop during installation or replacement.