Parts for Hot Point RGB518PCD2CT: Control Panel & Cooktop Parts

This left end cap is a direct-replacement trim piece that restores the finished edge and secure fit of the appliance door or panel. It helps maintain appearance and keeps adjoining trim and seals in place. What it does

• Covers and protects the exposed end of a door or trim piece to prevent sharp edges and wear
• Secures adjacent trim or retainer pieces so gaskets and panels stay aligned
• Stops drafts and reduces the chance of debris getting behind trim
• Common symptom: end cap cracked, loose, or missing causing visible gap or loose trim

• One left end cap

• Basic hand tools typically required; keep fasteners from the original part for reassembly
• Remove surrounding trim or door panel carefully to avoid damaging clips or gaskets
• Inspect adjacent trim and seals while installing; replace any damaged clips or screws as needed
• If work requires removing electrical panels, disconnect power first and follow manufacturer safety instructions

This spark module controls the spark to gas burners so they ignite reliably. Replacing a failed module restores proper electronic ignition for surface burners and stops unsafe/no-start conditions. What it does:

• Sends timed high-voltage sparks to burner igniters so gas lights on command.
• Stops continuous clicking or no-spark conditions when the module has failed.
• Restores consistent ignition across affected surface burners when used with compatible igniters.
• Helps prevent prolonged gas flow from repeated failed ignition attempts by restoring normal operation.

• Disconnect electrical power and shut off gas supply before starting any work.
• Handle connectors carefully; match wire locations and secure all plugs fully.
• Test for proper operation after installation and check for gas leaks before regular use.

Color: Black. Measures about 9 inches wide by 9 inches deep.

Bisque

This replacement screw secures appliance components so panels, brackets, and trim stay tight and aligned. Use it to replace a missing, stripped, or rusted fastener and restore a solid, rattle-free fit in the affected assembly.

• Fastens parts to the chassis/frame or mounting brackets
• Replaces lost, damaged, or corroded hardware
• Can help address loose or vibrating panels and minor misalignment
• Maintains a secure attachment during normal operation

• Disconnect power before servicing; for gas appliances, also shut off the gas supply
• Match the screw to the original location and reuse any clips or washers if present
• Start threading by hand to avoid cross-threading; tighten snugly without overtightening
• Repair/replace damaged receiving threads or clip for proper hold