Parts for Ge PT925SN2SS: 01 - Control Panel Parts

Fix an unresponsive oven control panel or blank display with this control display module. Shows settings, temperature, and accepts commands. DIY repair.

Fix a stuck or misaligned oven drawer with this slider assembly base. Restores smooth gliding action when drawers won't open or close properly.

Replace worn or missing oven door top insulation. Installs at the upper edge of the door to provide thermal protection and sound dampening. Essential part.

Protective cover for your wall oven's electronic touch board assembly. Replace if cracked, broken, or missing to restore the clean appearance of your control panel.

Fix a stuck or misaligned oven drawer with this slider assembly base. Restores smooth gliding action when drawers won't open or close properly.

Spacer that fits behind oven door handles to ensure proper alignment and fit. Replace if cracked, missing, or worn to restore a snug, finished appearance.

Stainless steel door handle for 30-inch wall ovens. Installs on the exterior door panel. Replace if cracked, bent, discolored, or missing hardware.

Replaces cracked, shattered, or damaged oven door window pack assembly. Restores clear exterior appearance on upper or lower oven doors. Direct fit.

Replace your wall oven's outer door panel assembly if damaged, dented, discolored, or scratched. Restores the front appearance of your oven door.

Upper hinge receiver for oven doors. Secures the door hinge assembly to the cabinet frame. Replace if cracked, broken, or missing for proper alignment.

Mounting screw secures panels, trim, and brackets inside your oven. Replace if lost, stripped, or damaged during service to keep components aligned.

Replacement screw for securing components inside your range or oven. Needed when original fasteners are stripped, lost, or damaged during repairs.

Hex head mounting screw for ranges and ovens. Secures elements, panels, and internal components. Replace if stripped, missing, or damaged during repairs.

Replacement mounting screw for ranges and ovens. Secures panels, brackets, or components during installation. Order a new screw if original is missing or stripped.

A small replacement spring wiper that restores proper contact pressure and wiping action on the appliance component it services. Replaces a worn or broken wiper spring to help maintain consistent performance and reliable operation. What it does:

• Provides tension and a wiping contact surface where the original spring wiper has worn or failed
• Restores consistent electrical/contact or mechanical wiping action that can affect operation
• Commonly replaced when loose, bent, broken, or when intermittent contact is observed
• Helps prevent arcing, poor contact, or inconsistent component movement when functioning correctly

• One spring wiper

• Evaluate the surrounding components and match before installing; replace only the part(s) explicitly specified
• Use proper tools and avoid bending or overstretching the spring during installation
• Disconnect power to the appliance before accessing or replacing electrical/contact components

Oven door not communicating properly? This door signal harness restores electronic communication between the door and control board. Easy DIY fix.

Wire harness connecting relay board to sensor in wall ovens. Replace if wires are frayed, connectors damaged, or harness is melted or broken.

Wire harness assembly connecting sail switch and temperature probe in wall ovens. Replace if wires are frayed, connectors damaged, or harness is worn.

LED ribbon connector for electric wall ovens. Connects LED lighting strips to the control board. Replace if cracked, corroded, or causing loose connections.

10-32 machine screw secures panels, brackets, door hinges, and handles in ovens and ranges. Replace missing, stripped, or broken screws for tight fit.