Parts for Ge CS975SD3SS: Control Panel Parts

Replacement burner control knob for your range. Restores control of stovetop burners when original knob is cracked, broken, loose, or missing.

Control knob for range burner selection. Installs on control panel to replace cracked, loose, or missing knobs. Push-on design restores secure turning.

This knob assembly is the control knob used to select settings on a range or cooktop. It restores user control and replaces damaged, loose, or missing knobs so burners and oven functions can be adjusted safely and accurately. What it does:

• Replaces a cracked, stripped, or missing control knob to restore manual control
• Allows selection of heat levels and oven/burner functions with a secure fit
• Resolves symptoms like a knob that won't turn, slips on the shaft, or won't stay set
• Fits standard control shafts commonly used on GE ranges and cooktops

• One knob assembly

• Disconnect power to the appliance before removing or installing the knob
• Most installations are simple: pull the old knob straight off the control shaft and push the new knob onto the splined shaft until it seats
• If the knob is tight or stuck, use a gentle rocking motion; avoid excessive force to prevent shaft damage

This SCR (silicon controlled rectifier) is a replacement electronic control component used to regulate power to heating elements and motors in compatible appliances. It restores proper switching to help the appliance run reliably. What it does:

• Controls and switches electrical current in oven/range control circuits and other appliance modules
• Helps the appliance reach and maintain proper heat or motor operation by enabling precise power delivery
• Commonly replaces a failed or intermittent rectifier that causes inconsistent heating, no heat, or erratic motor behavior
• Matches the OEM function and form for straightforward replacement when the original SCR is damaged

• One SCR 8-18 1/4 replacement rectifier

• Disconnect power to the appliance before servicing to avoid shock or damage
• Handle the part carefully; avoid touching terminals and use proper ESD precautions when required
• Verify wiring and terminal orientation match the original part before final installation

Replacement mounting screw that secures the thermostat assembly to your range cabinet. Replace if stripped, missing, or damaged during repair work.

Burner won't heat or stays on constantly? The infinite control switch regulates burner temperature. Simple DIY fix with basic tools in under 30 minutes.

Fixes continuous clicking or failure to light burners. This ignition switch activates the spark module when you turn the knob. Easy DIY repair.

This electronic oven control replaces the range's main user interface and control module to restore bake, broil, timing, and display functions. It provides the board and display assembly that directs oven heating cycles and user commands. What it does:

• Manages oven bake/broil cycles, timers and clock display
• Processes touchpad/selector inputs so oven responds to user settings
• Controls relay outputs that signal heating elements and safety circuits
• Commonly used when the display is blank, touchpad is unresponsive, or oven will not start heating

What's included:

• One electronic oven control assembly (ERC3HP) as shown

Install notes:

• Disconnect power at the breaker or unplug the appliance before servicing
• Handle the control and display carefully to avoid static or physical damage
• Reconnect all wiring harnesses and secure mounting screws per factory orientation

Decorative trim skirt that fits around range control knobs on the front panel. Replace if cracked, disintegrating, melted, or missing for a clean look.