Parts for Kenmore 587.15189402 (58715189402, 587 15189402): Control Panel Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Replace your dishwasher's touch pad control panel if buttons are unresponsive, the overlay is cracked, or the panel shows wear. Restores control interface.

Replace your dishwasher's broken or missing control knob. This knob attaches to the front panel and allows you to select wash cycles and settings.

Color: Black

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Replacement care guide and operating manual for your dishwasher. Provides setup, usage, and maintenance instructions if original was lost or damaged.

This Energy Guide label is the factory replacement adhesive sticker that displays the appliance's estimated annual energy use and operating cost. Keeps required efficiency information visible and legible for buyers or service. What it does

• Replaces the original Energy Guide information sticker used to show estimated yearly energy consumption and cost.
• Restores a readable efficiency label when the factory label is damaged, worn, or missing.
• Helps maintain correct product identification and energy disclosure for resale or inspection.
• Fits where the original label was mounted and adheres to the appliance surface.

• One adhesive Energy Guide label (single sticker)

• Clean and dry the mounting area before applying; adhesive bonds best to smooth, grease-free surfaces.
• Peel backing and press firmly, smoothing out air bubbles.
• Do not use as a structural or functional part—label only; follow appliance warnings and safety instructions.

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

Replacement wire harness for dishwashers. Connects control board to power components. Replace if wires are burned, melted, frayed, or connectors damaged.

Replacement mounting screw for dishwasher panels and internal components. Secures brackets and chassis parts. Replace stripped, missing, or damaged hardware.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.