Parts for Kenmore 587.16182400 (58716182400, 587 16182400): Control Panel Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Replace your dishwasher's touch pad control panel if buttons are unresponsive, the overlay is cracked, or the panel shows wear. Restores control interface.

Replace your dishwasher's broken or missing control knob. This knob attaches to the front panel and allows you to select wash cycles and settings.

Color: Black

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Replacement care guide and operating manual for your dishwasher. Provides setup, usage, and maintenance instructions if original was lost or damaged.

This replacement Energy Guide label is the adhesive sticker that displays an appliance's official energy use and efficiency information. It restores missing or unreadable labeling so buyers and service techs can see the appliance's energy guidance. What it does

• Replaces a torn, faded or missing Energy Guide sticker so the appliance shows its official energy-use information.
• Restores readable energy and efficiency details typically found on refrigerators and similar appliances.
• Helps clarify operating cost and efficiency ratings for resale, service, or inspection.
• Cosmetic replacement only—does not affect appliance operation or performance.

• One Energy Guide label (adhesive sticker)

• Clean and dry the installation area; remove old adhesive residues before applying.
• Peel and stick the label in the original location; align carefully—adhesive is permanent once applied.
• No tools or electrical disconnection required for label replacement; handle gently to avoid creasing.
• Replace only with the correct OEM label for accurate energy information.

Replacement wire harness for dishwashers. Connects control board to power components. Replace if wires are burned, melted, frayed, or connectors damaged.

Original owner's manual for your dishwasher. Provides operating instructions, maintenance guidelines, and troubleshooting tips. Needed if lost or damaged.

Replacement mounting screw for dishwasher panels and internal components. Secures brackets and chassis parts. Replace stripped, missing, or damaged hardware.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.