Parts for Kenmore 587.16193402 (58716193402, 587 16193402): Control Panel Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Replacement control panel touch pad for your dishwasher. Installs on the front door to restore button functionality. Needed when pad is cracked or worn.

Replace your dishwasher's worn, cracked, or unresponsive touch pad control panel. This component installs on the front console to restore button functionality.

Fix dishwasher not responding to buttons or display issues with this electronic control board. Restores normal operation and panel functions.

Replace your dishwasher's broken or missing control knob. This knob attaches to the front panel and allows you to select wash cycles and settings.

Color: Black

Includes actuator

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Includes actuator

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

Replacement care guide and operating manual for your dishwasher. Provides setup, usage, and maintenance instructions if original was lost or damaged.

This is a replacement Energy Guide label designed to restore the factory energy-rating sticker on compatible refrigerators. It provides the visible energy-use and efficiency information originally displayed on the appliance. What it does:

• Replaces a lost, damaged or faded Energy Guide sticker so energy information is visible
• Restores the appliance's factory energy-rating label for resale, inspection, or record-keeping
• Helps users confirm energy usage information at a glance
• Adhesive-backed for easy placement in the original label location

• One replacement Energy Guide label (adhesive-backed)

• Clean and dry the mounting area before applying to ensure proper adhesion
• Align carefully; press firmly across the label to secure
• For best results, apply at room temperature and avoid repositioning once adhered

Replacement mounting screw for dishwasher panels and internal components. Secures brackets and chassis parts. Replace stripped, missing, or damaged hardware.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.