Parts for Kenmore 587.16249700 (58716249700, 587 16249700): Control Panel Parts

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

Replace your dishwasher's touch pad control panel if buttons are unresponsive, the overlay is cracked, or the panel shows wear. Restores control interface.

Replace your dishwasher's broken or missing control knob. This knob attaches to the front panel and allows you to select wash cycles and settings.

Color: Black

Mounting screw for dishwasher assembly. Secures internal components and panels. Replace if missing, stripped, or corroded during maintenance or repair.

Replacement care guide and operating manual for your dishwasher. Provides setup, usage, and maintenance instructions if original was lost or damaged.

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.

This repair parts list is a parts-diagram sheet that helps identify and locate replacement components when servicing the appliance. It speeds part identification so technicians and DIYers can order the correct parts with confidence. What it does:

• Shows exploded views and part numbers to identify worn or broken components
• Useful for diagnosing which assembly or component to inspect or replace
• Serves as a quick-reference during repairs or parts ordering

• Not a wearable or consumable part; keep with the appliance or service records
• Use only as a reference—follow the full service manual and OEM instructions for repairs
• Always disconnect power and water supplies before accessing internal parts

Replacement wire harness for dishwashers. Connects control board to power components. Replace if wires are burned, melted, frayed, or connectors damaged.

Replacement mounting screw for dishwasher panels and internal components. Secures brackets and chassis parts. Replace stripped, missing, or damaged hardware.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Dissolves limescale, mineral deposits, and odor-causing residues from dishwasher tub and spray system. Use monthly to maintain peak cleaning performance.