Parts for Lg DLEX8100V: Control Panel And Plate Parts

The Pcb Assembly,display is an OEM part for LG dryers. This display PCB assembly serves as the interface between you and your appliance. It provides you with a user-friendly interface to select and control various settings and cycles, ensuring a convenient and efficient drying experience.

A bad display PCB assembly can occur due to electrical issues, component failure, or other internal malfunctions. If you notice symptoms such as the display not lighting up, unresponsive buttons or controls, or error messages appearing on the screen, it may be time to replace the display PCB assembly.

Symptoms of a bad display PCB assembly include:

• Display not lighting up
• Unresponsive buttons or controls
• Error messages appearing on the screen

Restore the function of your LG dryer by replacing the faulty display PCB assembly with this genuine OEM part. This OEM LG part can also be used on Kenmore/Sears appliances. 

Fix a dryer that won't power on or turn off with this main control board. Moderate DIY repair taking about 25-30 minutes with basic hand tools.

Upper mounting plate for dryer assembly. Replaces cracked, broken, or missing plates. Essential structural component for secure installation and support.

This door hinge assembly restores smooth, secure door movement. Worn or bent hinges can cause a misaligned door that won't close or seal properly—replacing the hinge brings back proper alignment and reliable operation.

• Supports the door and provides the pivot point for opening and closing
• Maintains correct alignment so the latch/strike engages properly
• Helps ensure an even seal to prevent leaks or air gaps
• Common symptoms: sagging or rubbing door, difficulty closing or latching, door popping open, squeaking/loose movement

• Disconnect power before service; shut off water supply if applicable to your appliance.
• Support the door to prevent stress on glass and cabinet while removing the hinge.
• Remove mounting screws; transfer any brackets or bushings from the original hinge as designed.
• Align the new hinge, tighten screws evenly, and verify smooth operation and proper latch/seal contact.

This replacement knob assembly restores tactile control for a range or cooktop control. It provides a secure grip and clear detent positions so you can set burner or surface settings reliably. What it does:

• Replaces a worn, cracked, or missing control knob to regain safe, predictable control
• Engages the shaft and detents so settings stay put during use
• Helps eliminate slipping or difficulty turning the control
• Matches original fit and function for direct replacement

• One knob assembly as shown

• Turn power/gas to the appliance off before servicing; follow appliance manufacturer safety instructions
• Remove the old knob by pulling straight off the control shaft; press the new knob onto the shaft until it seats
• Wear work gloves to protect hands from sharp edges during access