Parts for Ge PTS9200SN2SS: Control Panel & Upper Door Parts

This RJ45 mounting bracket secures an RJ45 network/communication jack to the appliance frame, restoring proper connector alignment and mechanical support. It's a simple replacement part for damaged or missing brackets. What it does:

• Holds the RJ45 jack firmly in place to prevent connector movement and intermittent connections
• Aligns the jack for easy cable insertion and secure mating
• Protects the connector and wiring from strain or damage during use
• Helps restore reliable network/communication port positioning after panel or bracket damage

• One RJ45 mounting bracket

• Unplug the appliance or disconnect power before servicing
• Remove the access panel or trim to reach the existing bracket; retain fasteners for reassembly
• Gently disconnect the jack/cable before removing the old bracket; avoid pulling on wires
• Hand-tighten or torque screws to manufacturer specifications; do not overtighten

Replace worn or missing oven door top insulation. Installs at the upper edge of the door to provide thermal protection and sound dampening. Essential part.

A small replacement spring wiper that restores proper contact pressure and wiping action on the appliance component it services. Replaces a worn or broken wiper spring to help maintain consistent performance and reliable operation. What it does:

• Provides tension and a wiping contact surface where the original spring wiper has worn or failed
• Restores consistent electrical/contact or mechanical wiping action that can affect operation
• Commonly replaced when loose, bent, broken, or when intermittent contact is observed
• Helps prevent arcing, poor contact, or inconsistent component movement when functioning correctly

• One spring wiper

• Evaluate the surrounding components and match before installing; replace only the part(s) explicitly specified
• Use proper tools and avoid bending or overstretching the spring during installation
• Disconnect power to the appliance before accessing or replacing electrical/contact components

Fix a stuck or misaligned oven drawer with this slider assembly base. Restores smooth gliding action when drawers won't open or close properly.

Seals your wall oven door to retain heat and improve efficiency. Replace if worn, cracked, or no longer sealing properly. Confirm fit with your model number.

Upper window pack assembly that replaces a cracked or damaged refrigerator door window panel, restoring appearance and helping protect the components behind the outer window. What it does:

• Replaces the upper door window pack to restore a clear, finished exterior on the appliance door.
• Addresses visible damage symptoms such as cracked, scratched, cloudy or broken window panels.
• Protects internal door components from exposure to moisture and debris.
• Matches the OEM-style mounting points for a like-for-like replacement when used with the correct model parts.

• Disconnect power and remove food from the door area before starting any repair.
• Handle the window pack carefully; wear cut-resistant gloves and eye protection when removing broken or cracked pieces.
• Remove any trim or fasteners per the appliance's service instructions; retain mounting screws and gaskets as needed.
• Refer to the OEM service manual or diagram for model-specific removal and reassembly steps.

Upper hinge receiver for oven doors. Secures the door hinge assembly to the cabinet frame. Replace if cracked, broken, or missing for proper alignment.

Mounting screw secures panels, trim, and brackets inside your oven. Replace if lost, stripped, or damaged during service to keep components aligned.

Hex head machine screw with 10-32 thread, 1-3/4 inches long. Secures brackets, panels, and internal oven components. Replace missing or stripped screws.