Parts for Ge PSB9240BL3TS: Control Parts

Control board bracket secures the electronic control board in your microwave. If your control board is loose or rattling, this mounting bracket restores stability.

Display holder bracket for built-in and over-the-range microwaves. Secures the control panel display assembly. Replace if cracked, broken, or missing.

This LED board powers and/or controls interior lighting so the appliance interior is illuminated for easier visibility. Replaces a failed or dim LED module to restore consistent, energy-efficient light in the compartment. What it does:

• Provides LED illumination for the appliance interior or compartment.
• Supplies light when the door is opened or when the interior lighting circuit is activated.
• Commonly replaced when lights are dim, flicker, intermittently work, or do not light at all.
• Works with the original mounting and wiring harness to integrate with factory controls.

• Disconnect power to the appliance before servicing to avoid shock.
• Handle the board by its edges and avoid touching LEDs or circuitry.
• Verify proper alignment and secure mounting; reconnect any plugs fully.

Selector knob or dial stopped working? This encoder board translates rotary control input into signals. Moderate DIY repair requires control panel removal.

Microwave not heating or buttons unresponsive? This main control board manages all functions. Moderate DIY repair restores full operation. Verify model fit.

Microwave not powering on or controls unresponsive? This PCB wire connector restores electrical connections between circuit boards. Quick 15-minute fix.

If your microwave won't start, has no display, or stops heating, the power control board likely failed. This electronic PCB restores normal operation.

Microwave not working or no power? The relay board controls power distribution to the magnetron and fan. Requires control panel removal to install.

A replacement board supporter that secures the appliance control board to the cabinet, helping keep the board stable and positioned away from wiring and chassis. Restores proper mounting to reduce vibration and movement of the control board. What it does:

• Holds and supports the control/PC board to prevent excessive movement or rattling
• Keeps the board spaced from the chassis and wiring to reduce risk of shorting or contact
• Helps maintain stable electrical connections for reliable control operation
• Reduces noise caused by a loose or vibrating control board
• Can prevent further wear on board mounting points and connectors

• Disconnect power to the appliance before beginning any service.
• Handle the control board by its edges and avoid touching components; use ESD precautions if available.
• Remove nearby panels or components as needed for access; retain all fasteners for reassembly.
• If mounting points or fasteners are damaged, inspect nearby parts and replace as required.