Parts for Crosley CFD27WIPS3: Controls & Ice Dispenser Parts

Fix a refrigerator not making ice or dispensing water with a new water inlet tube. Restores proper flow from valve to ice maker and dispenser.

This trim facade is the front decorative trim piece that finishes the appliance's control area and improves the cabinet appearance. It replaces cracked, scratched, or discolored trim to restore a clean, finished look. What it does:

• Covers and protects the front edge of the control panel or cabinet opening
• Restores a uniform, finished appearance when original trim is damaged or worn
• Helps keep dirt and moisture from reaching internal panel edges
• Fits to the appliance using existing clips or fasteners for a secure fit

• Disconnect power to the appliance before starting work
• Remove any surrounding trim or screws as needed to access clips or fasteners
• Align trim with existing mounting points and press or secure with original hardware
• If clips or screws are damaged, replace them before final installation

Decorative trim facade panel for bottom-mount refrigerators. Replaces cracked, broken, or missing exterior trim pieces to restore appearance.

Fix a cracked or discolored dispenser trim on your refrigerator. This gray trim frames the water and ice dispenser area, restoring the clean look of your door.

The Dispenser Module is an OEM component specifically designed for Frigidaire refrigerators. This module dispenses filtered water and crushed ice through the refrigerator door.  

Causes of a bad dispenser module can include worn gears or l

Fix water pooling under crisper drawers with a new refrigerator drain sump. Replaces cracked or clogged sumps causing leaks. Moderate DIY repair.

Replacement sump that collects and channels condensation and defrost water into the refrigerator drain system, helping stop leaks and pooling under shelves or inside the cabinet. Restores proper drainage and reduces water buildup. What it does:

Catches drips and splashes at the base of your refrigerator's ice and water dispenser. Replace this tray if it's cracked, broken, or missing.

Replacement mounting screw for refrigerators and freezers. Secures shelves, handles, panels, and brackets. Replace missing, stripped, or rusted screws.

Fix a blank or flickering display, non-working ice/water dispenser, or intermittent beeping. This control board replacement takes 10-15 minutes with basic tools.

Replacement mounting screw for refrigerators and freezers. Secures shelves, handles, panels, and brackets. Replace missing, stripped, or rusted screws.

Refrigerator not powering on or experiencing electrical failures? This wire harness restores reliable connections between components for proper operation.

Fix ice buildup and frozen water dispenser issues with this dispenser heater kit. Prevents frost clogging in the chute and valve area. Moderate DIY repair.

Connects dispenser controls and components in the refrigerator door. Replace if the wiring is damaged, frayed, or causing intermittent dispenser operation.

Connects refrigerator water line to inlet or valve with secure seal. Replace if cracked, leaking, or damaged to restore proper water pathway connection.

Ice maker not filling or leaking water? This water tube kit connects your water supply to the ice maker assembly. DIY-friendly repair for slow ice production.

Fix no water or ice issues with this refrigerator water tube. Restores flow from inlet valve to dispenser and ice maker when the original is cracked or leaking.

Routes water from inlet valve to dispenser and ice maker. Replace if tube is cracked, leaking, kinked, or damaged to restore proper water routing.

The Fill Tube Kit is an OEM part for Frigidaire refrigerators. It contains the tubes used to direct water from the water supply line into the refrigerator's water dispenser and ice maker. As these tubes can degrade over time due to mineral buildup

Connects sections of water tubing inside your refrigerator. Replace this adapter if cracked, leaking, or popping off to stop drips and water damage.