Parts for Electrolux EFDC317TIW0: 04 - Controls / Top Panel Parts

This replacement door gasket seals the appliance door to maintain a tight, even seal that helps control temperature and prevent leaks. It restores proper door closure and reduces energy loss when the original gasket is cracked, torn, or hardened. What it does:

• Creates a continuous barrier between the door and cabinet to keep internal air in and outside air out
• Prevents water and air leaks that can lead to frost build-up or inconsistent temperatures
• Improves appliance efficiency by reducing cold/hot air exchange across the door
• Helps the door latch and close evenly for reliable operation

• One door gasket/seal

• Disconnect power to the appliance before starting any repairs
• Remove the old gasket by gently pulling from the door frame; clean the gasket channel before installing the new seal
• Work around the door evenly, pressing the new gasket into the channel to avoid stretching or twisting
• If the gasket is tight after install, allow time for it to relax into place; use care with sharp tools to avoid damage

This top panel in white restores the oven/stove's upper exterior, improving appearance and protecting internal components from spills and debris. It's a direct-replacement exterior shell piece designed to match original fit and finish. What it does:

• Replaces a cracked, warped, dented, or discolored upper cabinet panel
• Protects control housing and internal components from grease, spills, and dust
• Restores a flush, finished look to the appliance top and backguard area
• Helps maintain proper alignment for control and trim pieces

• Disconnect power to the appliance before beginning any work
• Typical removal requires removing screws and lifting the old panel straight out; keep mounting hardware
• Handle edges carefully to avoid cuts and protect the painted finish during installation

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic