Parts for Electrolux EFMG617STT0: 04 - Controls / Top Panel Parts

Fix unresponsive buttons or blank displays with this user interface control board. Restores keypad function and display readings on your laundry center.

The Knob Assembly is an OEM part for Frigidaire dryers. It allows you to select and adjust the dryer's settings and cycles.

A bad knob assembly can be caused by wear and tear, damage, or a faulty internal mechanism. Signs of a faulty knob assembly include the knob becoming loose, cracked, or difficult to turn.

Symptoms of a bad knob assembly can include:

• The knob becoming loose 
• Cracks or breaks in the knob
• Difficulty in turning the knob

Replace your worn-out or damaged knob assembly with this genuine OEM part to restore control over your dryer's settings. This Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.
 

Fix uneven drying or excess noise with this air flow diffuser. Directs airflow inside your dryer for consistent temperature and quieter operation.

This metal top panel replaces the upper rear control housing on compatible Frigidaire ranges and stoves, restoring a secure mounting surface for controls and improving cabinet fit and appearance. Ideal for repairing bent, rusted, or damaged panels. What it does

• Replaces the upper rear housing that supports control knobs, switches and the backguard area
• Restores proper alignment and spacing between the cooktop and rear controls
• Stops light leaks and relieves stress from warped or bent panels
• Commonly used when the panel is dented, rusted, cracked, or has broken mounting tabs

• One top panel

• Disconnect power (and gas, if applicable) before starting any work
• Handle sharp sheet-metal edges with gloves; panel edges can be sharp
• Remove control knobs, backguard, or trim as required and save screws for reinstallation
• Align mounting tabs and secure with original hardware; test controls after reassembly

Replaces a cracked, damaged, or worn control console on laundry centers. Restores the mounting surface for buttons, knobs, and displays to fit securely.

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize

This factory 8-18 screw secures appliance panels, brackets, and components. Replace missing or stripped hardware to restore a tight, rattle-free assembly and dependable operation.

• Fastens components to frames, brackets, and covers
• Replaces missing, damaged, or rusted screws
• Helps reduce looseness, vibration, and rattling noises
• Restores proper alignment of panels and assemblies

• Disconnect power before servicing; shut off gas/water if applicable
• Start the screw by hand to avoid cross-threading; use the proper driver
• Tighten snugly—do not overtighten to prevent stripping metal or plastic