Parts for Kenmore 8404: Controls / Top Panel Parts

Dryer won't turn off or advance cycles? This control timer regulates cycle progression and automatic shutoff. Moderate DIY repair restores timing.

Replace your cracked, broken, or missing dryer control knob. Restores tactile grip and clear position indication on the control panel shaft.

This clip is a small plastic retainer designed to secure trim and lightweight panels so they stay in place and reduce rattling or gaps. It restores proper fit and helps keep parts aligned for a finished look. What it does:

• Secures trim pieces, panels, or grill components to the appliance frame
• Prevents loose or rattling parts that can cause noise or misalignment
• Holds components in correct position so doors and panels close properly
• Replaces worn or broken clips that no longer grip reliably

• Remove power or disconnect the appliance before servicing when applicable
• Clip installs by snapping into pre-existing mounting hole or slot; no special tools usually required
• Inspect mating surfaces and replace any additional damaged fasteners for best fit

Dryer won't start when you turn the knob? A faulty start switch prevents the motor from engaging. Simple 5-10 minute DIY fix with basic tools required.

Control board mounting bracket for dryers. Secures the electronic control board to the dryer frame. Replace if bracket is cracked, bent, or missing.

Secures panels, brackets, and trim on appliances. Replace when missing, stripped, or damaged to restore a tight, rattle-free fit and proper alignment.

White top panel for stackable dryers. Replaces cracked, damaged, or discolored panels. Installs on top of dryer unit to restore appearance and protect.

Official use and care guide manual for your dryer. Replace lost, damaged, or outdated instructions. Provides setup, operation, and maintenance guidance.