Parts for Whirlpool GW395LEPQ04: 01 - Cooktop Parts

This part has been discontinued and is no longer available

Hex head sheet metal screw secures appliance panels, brackets, and trim. Replace missing, stripped, or damaged screws to keep covers firmly attached.

Color: White. Right hand side

Color: Biscuit. Left hand side

Color: Biscuit. Right hand side

Color: Stainless steel. Left hand side

Color: White. Left hand side

Color: Stainless steel. Right hand side

Color: Black. Left hand side

Color: Black. Right hand side

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit

Color: Black.

Color: espresso. For grate pads order 8183759.

Color: Espresso. For grate pads order 8183759.

Color: Mouse grey. For grate pads order 8183759.

Color: Mouse Grey. For grate pads order 8183759.

Color: Black. For grate pads order 8183759.

color: Black. For grate pads order 8183759.

Replacement mounting screw for securing panels, brackets, covers, and trim pieces in appliances. Restores fit when hardware is missing, stripped, or lost.

The Range Screw is an OEM part for Whirlpool ranges. It is a small but essential component used to secure various parts and panels of the range. It is designed to fit securely into pre-drilled holes, holding components tightly in place.

There are a few factors that can lead to a bad Range Screw. Over time, screws may become loose or stripped due to frequent use or inadequate tightening. Accidental cross-threading or overtightening can also damage the screw or the surrounding components.

Symptoms of a bad screw may include loose or wobbly parts, rattling noises during operation, or difficulty in keeping components securely attached. This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

This fixed thermostat switches near 60C to control a heat-managed circuit—often the oven's cooling/blower fan. Replacing a failed unit restores proper fan cycling and helps protect the control area from excessive heat during and after cooking.

• Monitors temperature in the oven cabinet/control area and switches power based on heat level
• Cycles the cooling/blower fan on and off to manage cabinet temperature
• Helps safeguard electronic controls from heat buildup
• Failure may cause symptoms such as a fan that won't run, a fan that runs continuously, or an unusually hot control area

• Disconnect power at the breaker before servicing
• Access the thermostat per your model; it is typically mounted to a plenum or bracket near the oven cavity
• Move wires one at a time and mount the new thermostat flat against the surface for accurate sensing
• Restore power and verify the fan cycles during operation

Color: Black.

Color: White. Rear

Color: Stainless steel. Rear

Color: Biscuit. Rear

Color: Black. Rear

Fix uneven flames or poor heating with this cooktop burner cap. Covers the burner head for proper gas distribution. Simple 5-minute replacement.

Color: Gray. Size: Small. For black order WP3191898. For the large cap order WP3191905.

Color: Mouse grey. Size: Large. 14,000 BTU.

Color: Black. Size: Large. 14,000 BTU.

This is a burner cap that sits on top of a gas range surface burner, distributing the flame evenly around the burner head. It helps ensure consistent heating and proper flame pattern during cooking. Replace this cap if it is cracked, warped, or corroded, or if you notice uneven flames or poor ignition on the burner.

Color: Gray. Size: Large. Matching small cap: WP3191899. Color options: Black WP3191904.

Color: Black. This large cap measures about 3 inches in diameter. For gray order WP3191905. For the small cap order WP3191898.

Color: black. Small size. Measures about 2-1/2 inches in diameter.