Parts for Whirlpool RC8700EDB0: 01 - Cooktop Parts

This replacement fan control knob restores smooth, reliable operation of your appliance's fan/blower. It replaces a cracked or missing knob so you can turn the fan on and adjust settings with a factory look. What it does:

• Attaches to the fan/blower control switch so you can select on/off and speed settings
• Restores control when the original knob is cracked, stripped, or missing
• Helps resolve symptoms like the knob slipping, spinning freely, or not turning the shaft
• Black finish matches the original appearance

• 1 black fan control knob

• Disconnect power to the appliance before servicing
• Pull the old knob straight off the control shaft
• Align the new knob with the shaft orientation and press it on until fully seated—do not force
• If the knob won't seat, inspect the control shaft for damage or debris

The Burner Knob is an OEM part for Whirlpool ranges and cooktops. This knob allows users to control the intensity of the stove's burner, offering a seamless interface for adjusting from a gentle simmer to a rolling boil. 

Over time, burner knobs can wear out or become damaged due to frequent use, exposure to heat, or accidental impacts. 

Symptoms of a bad Burner Knob include:

• Difficulty in adjusting the burner's flame or heat level
• The knob is loose or does not turn smoothly
• Visible cracks or damage to the knob
• The knob does not align properly with the burner settings

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This is a high-heat ceramic light receptacle used in select appliances. It provides a safe, insulated socket for the appliance light bulb so you can reliably see inside during use or service.

• Holds and insulates the bulb in high-temperature areas
• Restores lighting when the bulb is good but the light won't turn on
• Helps correct loose, flickering, or intermittent interior light
• Common signs include a cracked/scorched socket or arcing at the bulb base

• Disconnect power before servicing; allow the appliance to cool completely
• Access may be from inside the cavity or from the rear panel, depending on model
• Transfer wires one at a time to the new receptacle to maintain correct connections
• Install only the bulb type and wattage specified by the appliance manufacturer

This clip secures appliance panels or small components to maintain alignment and reduce vibration, restoring the original fit where a worn or broken fastener allows movement or rattling. Simple, direct-fit replacement when the original clip fails. What it does:

• Holds trim, panels, or small components in position to prevent rattling and shifting.
• Replaces broken or missing fasteners that allow loose or misaligned parts.
• Helps keep wiring harnesses or insulation routed and secured in assemblies.
• Small, inexpensive part commonly used wherever a retaining clip is specified.

• Always disconnect power (unplug or shut off circuit) before servicing the appliance.
• Remove panels or trim per the manufacturer service sheet to access the clip; note the clip orientation before removal.
• Use appropriate tools (needle-nose pliers, trim tool) and avoid over-bending the clip or adjacent parts.
• Replace them with the correct OEM-specified clips for reliable fit.

Screw: 8-16 x 3/8 inch.