Craftsman Hedge Trimmer Spring Parts

This extension spring attaches to the axle support bracket and the drive belt idler pulley on many types of lawn and garden equipment. It creates additional tension to the drive belt idler pulley. Sometimes the extension spring can be stretched out or may break, often caused through excess use. If this is the case, the spring will need to be replaced.If the spring is broken or no longer creates the appropriate amount of tension, replacement is required. It is an easy process that only requires a set of pliers. The pliers can be used to take the old spring off of the yard equipment before attaching the new extension spring. Make sure the equipment is on a stable surface and powered off when working with it. Remove the spark plug wire to prevent accidents.This extension spring is an authentic OEM replacement part sourced directly from the manufacturer. It is sold as an individual component. The spring is made to be used with lawnmowers, lawn tractors, and tillers created by MasterCut, Yard-Man, Bolens, Huskee, MTD, Yard Machines, Murray, Troy-Bilt, Cub Cadet, and Craftsman.

Vibration-dampening spring assembly that installs between the engine and handle. Replace if springs are broken, worn, or missing to restore proper isolation.

Extension spring for riding mowers and lawn tractors. Replaces worn, broken, or missing springs in various linkage and control systems. Direct fit part.

This replacement driver spring is a genuine OEM part for a string trimmer with a starter rope ignition. When an operator pulls the starter rope, the rope must recoil back into the starter assembly before it can be used again. This spring connects to a driver pulley in the starter assembly and maintains the right amount of tension needed to recoil the pulley. Over time, driver springs will begin to lose some of their tension. This is especially true if the operator is quite rough on their appliance. Pulling too hard on the starter rope can wear out the spring more quickly, making it less effective. Without a properly tensed driver spring, the starter rope will not recoil into the assembly. To change out the spring, use a nut driver to open the starter assembly and remove the pulley to get access to the old spring. Carefully remove it and install the new part. This replacement driver spring is a high-quality part designed to match the exact specifications for a Husqvarna or Jonsered appliance. This part is sourced from its original manufacturer and ships individually.