Parts for Lg TCWM2013QS3: Dispenser Assembly Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This single wire harness restores the appliance's factory wiring connections so electrical components and controls receive reliable power and signals. It replaces a damaged or worn harness to help return normal operation. What it does:

• Re-establishes electrical connections between controls and components
• Restores power/signal paths for sensors, motors, or switches
• Helps stop intermittent power, loss of function, or no-start conditions related to damaged wiring
• Prevents shorts or erratic behavior from frayed or broken wires

• Disconnect power (and water, if applicable) before starting any repair
• Compare new harness to the old one and route along the same path; secure all clips and ties
• Make sure all connector tabs fully engage; do not force mismatched plugs

Fix leaks or poor water flow with a new washer inlet hose. This part channels household water supply into your machine for proper filling and operation.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Pivot hanger assembly that supports and stabilizes washer components. Replace if worn, damaged, or causing misalignment to restore smooth movement.

Secures rubber hoses to fittings with constant spring tension to prevent leaks. Replace when rusted or weakened to maintain a tight seal. Confirm fit.

Water inlet hose that connects your washer to the water supply. Replace if cracked, leaking, or worn to prevent water seepage around your appliance.

This inlet hose carries supply water into the washer during the fill cycle. Replacing a worn or leaking hose restores proper water flow and helps prevent leaks and fill errors that can leave clothes unwashed or floors wet.

• Channels incoming water from the inlet valve into the washer
• Maintains a sealed connection to prevent drips and leaks
• Replaces hoses that are cracked, swollen, kinked, or clogged with mineral deposits
• Common symptoms: water leaking during fill, reduced water flow or fill error codes, visible cracks/splits

• Disconnect power and turn off both water supply valves before servicing
• Keep towels or a container handy; residual water may spill when removing hoses
• Note hose routing; fully seat ends and secure with existing or new clamps as required
• Restore water and power, then run a quick fill to check all connections for leaks

Directs water from inlet valve to detergent dispenser in LG washers. Replace if hose is cracked, leaking, won't stay attached, or damaged from wear.

Drain hose assembly connects your washer tub to the household drain. Replace if cracked, kinked, leaking at connections, or worn from age and use.

The Clamp is an OEM part for LG washing machines. It is used to secure the hose connections within the washer, ensuring that water flows correctly without leaks.

Over time, the clamp can become worn or damaged due to repeated exposure to water, vibration, or general wear and tear. If the clamp fails, it can lead to water leaks or hoses becoming detached.

Symptoms of a bad clamp include:

• Water leaking from hose connections
• Hoses coming loose or detaching during operation
• Visible rust or damage on the clamp
• Poor water flow or pressure issues

This OEM LG part is also compatible with Sears/Kenmore models.

Fix no hot water, slow filling, or screaming noise during fill. This washer water inlet valve controls water flow into the tub. Moderate DIY repair.

Fix a washer that won't fill, fills slowly, or leaks at the water connection. This inlet valve controls water flow into the tub. Easy DIY repair.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.