Parts for Ge GFC200-02: 01 - Section1 Parts

The Disposer Splash Guard and Stopper Kit is an OEM replacement part for GE garbage disposers. It includes replacement splash guard rings and stopper balls that fit beneath the disposer mount. These parts work to contain odors, drain water, and direct sound down the drain during operation.

Over time, the splash guard and stopper can wear out due to continuous exposure to food waste, water, and cleaning chemicals. Damage or deterioration of these components can lead to ineffective sealing, allowing water and debris to splash out or preventing the stopper from forming a tight seal.

Symptoms of a bad splash guard and stopper kit include:

• Water or food particles splashing out from the disposal
• Difficulty in plugging the sink for filling with water
• Unpleasant odors due to trapped food particles around the splash guard
• The stopper not fitting securely in the disposal opening

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Complete sink flange mounting kit for garbage disposals. Includes gaskets, seals, and hardware for secure installation. Replace if leaking or corroded.

Fiber flange gasket seals your disposer to the sink opening, preventing leaks. Replace if brittle, missing, or you see moisture around the drain.

Complete sink flange mounting kit for garbage disposals. Includes gaskets, seals, and hardware for secure installation. Replace if leaking or corroded.

Complete sink flange mounting kit for garbage disposals. Includes gaskets, seals, and hardware for secure installation. Replace if leaking or corroded.

This support ring is a mounting component that secures the garbage disposal unit to the sink flange. It holds the disposal in place beneath the sink drain opening and ensures a tight, leak-free connection. Replace this ring if it is cracked, warped, or damaged, which can cause the disposal to loosen, vibrate excessively, or leak at the mounting point.

Hex head mounting screw for garbage disposers. Replaces broken, stripped, or missing screws that secure disposer components during installation.

Specs: 10 - 32 t hex 7/16 s

This slinger is a molded water-deflecting washer part that directs water away from the transmission/motor area to help prevent leaks and premature component wear. It restores correct drainage and containment around the tub shaft. What it does:

• Directs escaping water away from the transmission and motor to reduce leak risk
• Helps protect seals and bearings from water exposure and corrosion
• Keeps water contained around the tub shaft for proper drainage
• Helps maintain reliable operation by preventing water-related damage

• Disconnect power and water supply before beginning any repair
• Access the tub/transmission area—remove cabinet or access panels as required
• Ensure correct orientation on the shaft and that mating surfaces are clean before installing
• Inspect nearby seals and bearings; replace if worn or damaged to avoid repeat leaks

Retaining ring secures internal components in your garbage disposer. Replace if loose, damaged, or during motor repairs. Verify fit with your model number.