How to Troubleshoot & Replace Ge AP3994841 / WE19M1490 Dryer Control Panel, White

After unplugging the dryer, I removed knobs and control panel. I removed the 3 connectors to start switch. I had to cut and replace one connector due to shorted wire which burnt the connector. I attached new connector and then attached these to start switch. I then remounted all three switches to new control panel and reattached control panel to dryer. Plugged in and started right up! Thank you for the helpful video. 

Just replaced the backsplash. About 15min easy fix. 

I'm a repair man for home improvements and remodels. Replaced face plate, switch and knob. Now it looks and works like new again. 

Got new front ant reinsert the old one 

Unplugged dryer from electric socket... Removed metal protector from rear of backsplash 6 screws ...disconnected all three electrical controls from faulty backsplash..(see videos for correct removal and replacement).... ....removed backsplash....placed new backspash...reinstalled original electrical controls onto rear of new backsplash.....secured backsplash with original metal protector and six screws.....replaced all knobs with new knobs.....plugged in dryer to electric socket...tested dryer ....all functions nominal and working correctly. The real challenge is removing and replacing the 3 electrical controls on the back of the backsplash without breaking the new backsplash.....retention clips on backsplash are plastic and thin and can break off easily as they did on the old backsplash through heavy use of the knobs. 

Ordered a new back(dash board) and put it in. Took 5 minutes. 

Control panel (back asy) Perfect. just what I needed. 

The replacement parts were an exact match. Swap out wires to the new switch and lock the switches back into the new backsplash plate. Everything fits right and if you have even a little experience with handy work, this will only take 5-15 mins. 

Yes, I replaced parts. 

Had to order the back assembly panel. Checked the part against the model number on the GE parts site on the internet. Unsnap the remaining switches from the old panel and transfer the switches to the new panel. Reattached the panel to the dryer with the six screws removed from the old panel.