Mike M Richmond , VA May 09, 2014 Washer wouldn't run just hummed Went to the site gave me all the info i needed and ordered the part and the video was awesome and i replaced the part in less than 10 min and its fixed !!!! thanks guys and awesome site !!!!!!! Read More... 47 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Tommy B New Smyrna Beach , FL November 13, 2015 Appliance: Whirlpool TAWB600EQ1 Would fill but no agitation or spin Watched 3 vid's on you tube...wasn't door switch, wasn't coupler. It looked great. Next we check capacitor and we didn't get any readings. It was one of your video's so we ordered the part from you..Happy, Happy, Happy Read More... 38 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set
Schuyler T Lithonia , GA January 19, 2020 My washer stopped working and when trying to get it to turn on, all it did was make a humming noise. I replaced the capacitor and also the washer pump due to leaking under the washer. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench, Screwdrivers
Jerry V West Simsbury , CT July 10, 2016 New capacitator and agitator dogs Installed new parts and machine working fine. Thanks Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set
Donald G Alburtis , PA September 20, 2019 Bad capacitor motor didn’t start under load Watched the video and changed the capacitor. Yes, it’s that easy. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Tammy W St. Albans , VT March 15, 2020 Capacitor. Replaced. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set
Jodie P Frankston , TX January 13, 2019 Post broke or burned of capacitor Replaced it.. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Madeline M Cookeville , TN January 20, 2018 Appliance: Model LSQ9564MQO Not start. Replace capacitor. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Joseph D Eastham , MA December 04, 2017 Appliance: Model WHIRLPOOL LSR8244D Motor hummed but machine did not start. Replace capacitor. Located under clamp on motor bracket. This is an early 1990 model Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers
Stephen D B Northbridge , MA October 25, 2017 Washer was smelling like burnt clutch then the run capacitor shorted out from trying to finish existing load Removed adjectator screw . removed adjectator propeller. Put washer on its back after dissembling hot and cold water feeds and waste pipe. Included and removed pump. Unclipped and removed motor. Pulled out shaft and Unclipped clutch assembly. Reassembled. Removed start capacitor and installed new one. Hooked all hoses up and started the machine and started washing backed up dirty laundry. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers, Socket Set