How to Troubleshoot & Replace Whirlpool AP6008072 / WP3355806 Washer Dryer Combo Lid Switch Kit

Used you tube to find video on process and then adjusted to fit my needs. 

Fixing the problem was quite simple. First, I removed the lid assembly (thanks to the diagrams supplied by AppliancePartsPros.com!). Getting the back two screws out was very difficult because I couldn't see them from the front and I could not move the unit out of the enclosed space. After some trial and error, I located the screws which were 5/16 hex head screws and removed them with a MAGNETIC nut driver. (The magnet assures that the screw will not drop down into the mechanism). Second, I unplugged the switch from the harness connector, inscribed the switch, and unscrewed the ground wire. Third, I removed the old rusted clips from the assembly and the switch came right out. Repacing with the supplied new switch was just the opposite of the above removal process. 

First I thought it may be the timer since it wasn't advancing to the next cycle, but after trying that it didn't seem to have any affect. Then I took the front cover of the wash machine off. This was a bit tricky...You have to pry the top piece forward past the bottom cover to get past the plastic pins. Then there are two screws holding the front plate in place. After removing them you can lift the cover off and get to the inside of the machine. Once I was able to see inside the washing machine I noticed the switch looked a little weak. I then pushed up on the switch and the washer went to the next cycle (I don't recommend having this hooked up to the power, should be able to tell that lid switch is bad without digging this deep). Ultimately I replaced the switch and got it working again. 

Ordered and re-place switch and (3) three shocks basically gutting the motor and tub assembly out and reassembling with the detailed instructions sent with new parts 

Initially suspected timer, but it did advance during some cycles. the schematic on the unit and other input on this site helped to confirm that the water level switch was at fault 

Just watching some of your appliancepartspros.com videos on how to do it and install it. 

Replace the switch with no difficulty. 

I needed a new lid switch .My machine is 20 yrs old 

It was a very easy repair. Two screws and pop the top off the washer. Then two more screws and a plug. Then reverse. 

Using the internet to diagnose the problem and identify the parts needed. I ordered the parts from AppliancePartsPros. They were shipped the same day and received two days later. Following the assembly and disassembly instructions that I located, I was able to change the parts within 1 1/2 hours. The machine works great. I was extremely pleased with the pricing and the quick shipping of parts from AppliancePartsPros.com.