Do-It-Yourself Story

Bearings started making noise when running. Turning drum you could feel it was not smooth. The online video was very helpful. Made a step by step written direction to follow. No real issues except driving out the inner drum shaft took more force than I had anticipated. Bearings and seals replaced without much issue. Given the corrosion on the the spider and shaft I would have replaced it if I had known it. I cleaned the shaft as best as possible but still had some minor pitting. I would replace next time. Drum section seal was replaced without any issues. Installed new vibration dampers (new pins are included no need to order separate ones like I did) and support springs but they probably didn't need to be replaced.. Hardest part was getting the tub/door gasket installed! All and All it took about 4 hours of time. Good luck