Ordered replacement spider, seals, bearings, shocks. Replaced all as long as was in there, though shocks looked good. Spider was not broken but shaft looked scruffy. The bearing seal had leaked and water took out both bearings. One spider bolt wouldn't come out because the nut spun in the plastic housing it was in. I fought that and won. Beating the bearings out and back in was not fun. I had to pound down against the rear bearings inner race against the inner tub to get the spline all the way through unlike the video. When it was all back together all worked except the cycle hung during spin. Got ue error. Tub turned stiff by hand. When I loosened the bolt attaching the rotor to the shaft, the tub started to rotate freer. I reapplied thread locker and just snugged the bolt. It works like new now. DONT overtighten.