Do-It-Yourself Story

I followed the Appliance Parts Pro's advice videos for the Maytag MAV6451AWW Atlantis washer on replacing the snubber ring and the suspension springs. Everything went just fine except replacing the two rear most suspension springs. None of the videos illustrated REINSTALLING the REAR springs which is extremely difficult because you can't get enough leverage with your arm extended. Observing my frustration, my wife recommended taking off the back side. You can't simply take off the back, because the right and left sides and the back are one piece. LESSON LEARNED: Follow the video to remove the front, then use duct tape to secure the lid to the left and right sides, and then remove ALL the screws around the base after removing the pump, motor and all hoses including the small water level sensing hose attached to the left rear of the tub. Make sure the motor wiring harness is unhitched from the base clip. Put on gloves because the edges are sharp, and then get your wife to help lift the remainder of the frame up and off the base. This makes removing the suspension springs and replacing them a piece of cake. Doing this originally would have saved hours of frustration.