Bought the kit and bearing installation tool. Video was quite helpful and we followed it all the way through. Only negative comment is that the bearing installation tool did NOT center the bearing spacer tube or the washer precisely enough and we could not even pound the drive shaft in past them. We had to lightly tap the lower bearing out a few thousandths of an inch to allow the spacer and washer to be centered. We re-centered the washer and spacer tube, then re-torqued with the tool. By chance they stayed centered the second time. Next time, a little tape on the tool portions that go through the bearings inner race hole would help center the spacer and washer. But all-in-all, the repair was quite easy.