Parts for HLC1700AXS: Door Parts

A small replacement housing screw that secures appliance panels and brackets, restoring proper fit and preventing rattles or loose panels. Fits common appliance housings where a short ST4 x 12 self-tapping screw is required. What it does:

• Fastens housing panels, trim, or internal brackets to maintain proper alignment and reduce vibration
• Replaces missing or damaged screws that cause loose or rattling panels
• Works with sheet metal and plastic mounting points designed for ST4 thread size
• Small, low-profile head designed for appliance interiors

• One housing screw (ST4 x 12)

• Disconnect power before servicing the appliance and work on cool surfaces
• Use the correct screwdriver or bit to avoid stripping the head
• Install gently and avoid overtightening to prevent thread or panel damage

This door plug is a small trim cap that covers exposed screw holes on the appliance door to restore a finished appearance and help keep fasteners protected from dust and grime. It's a simple cosmetic part that helps complete door trim. What it does:

• Covers and conceals exposed screw holes or hinge openings on the door
• Protects fasteners from dirt and corrosion by keeping debris out of holes
• Restores a clean, finished look to the appliance door
• Helpful when replacing door parts or trim to hide mounting points

• Push the plug into the opening until it snaps or seats flush; minimal force and no special tools usually required
• Confirm correct orientation and fit before final seating
• If removing the old plug, use a small flat tool gently to pry it out to avoid scratching surrounding trim
• Work with the door supported as needed; follow the appliance manufacturer's safety guidance and disconnect power if performing broader repairs

This door strike is the latch component that catches and secures a refrigerator/freezer door, restoring a proper seal and reliable closing. It replaces a worn or broken strike to help the door stay closed and aligned. What it does:

• Engages with the door latch to hold the door shut and maintain a tight seal
• Helps prevent doors from sliding open or failing to stay closed
• Stops cold air loss that can cause temperature issues and increased run time
• Reduces rattling or misalignment caused by a damaged or worn strike

• Disconnect power to the appliance before beginning any work
• Remove the inner door panel or access screws to reach the strike; keep track of mounting hardware
• Align the strike with the latch and tighten screws securely without over-torquing
• Test the door operation and seal after installation

This door hinge mounting plate secures the refrigerator door hinge to the cabinet, restoring hinge alignment and proper door operation. It's a direct-fit replacement that helps stop door sag and improves sealing. What it does:

• Provides a secure mounting point for the door hinge assembly on the cabinet
• Restores proper door alignment to help the door close evenly and seal correctly
• Stops hinge wobble or looseness that can cause uneven wear or gaps
• Helps address symptoms like door sagging, rubbing, or uneven closing

• Unplug the appliance or turn off power before beginning work.
• Support the door while removing hinge hardware to prevent dropping or damage.
• Use the correct hand tools and fasteners; avoid overtightening to prevent striping.