Parts for Ge ZIP360NZA: Doors Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

The Flapper Door Spring is an OEM part for GE refrigerators. It ensures the proper operation of the ice dispenser's flapper door by providing the necessary tension for the door to open and close correctly. This helps in maintaining the internal temperature and preventing warm air from entering the freezer.

You should replace the flapper door spring if it becomes worn out or damaged. Over time, the spring can lose its tension due to constant use, become bent or broken from mishandling, or suffer from rust and corrosion.

Symptoms of a bad flapper door spring include:

• The ice dispenser flapper door not closing properly
• Warm air entering the freezer compartment
• Increased frost buildup around the ice chute
• Unusual noises when the ice dispenser is used

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Guides the center door mullion spring pivot for smooth flap operation. Replace if worn or damaged to maintain proper door seal. Verify fit with model.

Trim cap that covers the refrigerator door hinge hardware. Replace if cracked, broken, or missing to protect the hinge and restore a finished look.

Seals your refrigerator door to maintain proper temperature and prevent cold air loss. Replace if worn, cracked, or loose to improve efficiency.

This articulating mullion assembly connects the oven mullion to the door, restoring smooth pivoting and alignment so the door opens and closes properly. It replaces a worn or broken mullion hinge to reduce sticking and misalignment. What it does:

• Provides the pivot point that lets the mullion move with the oven door for proper sealing and alignment
• Replaces worn or broken hinge action that can cause a door to hang, stick, or close unevenly
• Reduces noise from loose or damaged mullion linkage during door operation
• Helps restore even gaps and consistent door movement that affect oven sealing and performance

• One mullion articulating assembly

• Remove power to the appliance before servicing to avoid injury; follow manufacturer safety procedures
• Basic hand tools required; keep fasteners and orientation noted for reassembly
• Inspect adjoining mullion and door components for wear and replace if needed to ensure proper fit

Seals the fresh food compartment to prevent cool air loss and maintain proper temperature. Replace if torn, cracked, or no longer sealing tightly.

Insulated inner freezer door panel that provides structural support and thermal insulation. Replace if cracked, damaged, or worn to restore door integrity.

Seals freezer drawer to prevent cold air loss and frost buildup. Replace if torn, cracked, or causing ice formation. Verify fit with your model number.

Decorative trim piece for refrigerator freezer door handle. Replaces cracked, chipped, or discolored handle trim. Restores finished appearance.