Parts for Ge DPGT750GC0PL: 03 - Drum, Blower & Motor Parts

Replacement drum support roller assembly for dryers. Supports and stabilizes the drum as it rotates. Replace if roller is loose, wobbly, or worn out.

A lower-rack lifter that secures and guides the dishwasher's bottom rack for smooth movement and correct positioning. Restores proper rack height and alignment so dishes load, wash, and drain without interference. What it does:

• Supports and raises/lowers the lower dish rack to the correct operating position
• Keeps the rack aligned on its track to prevent binding or rough movement
• Reduces rack rubbing against tub walls and helps ensure proper spray-arm clearance
• Commonly replaced when the rack drops, won't stay level, or moves unevenly

• Disconnect power and turn off water supply before servicing dishwasher
• Remove lower rack to access and replace the lifter; no special tools typically required
• Verify proper seating on the rack guide and smooth operation before returning unit to service
• If other rack components are damaged, inspect for worn wheels or track issues

Transfers motor rotation to tumble clothes. Replace when belt shows wear, breaks, or causes slipping noise. Confirm fit with your model number.

Replacement lamp cover for your dryer's interior light. This plastic cover protects the bulb and lens. Order now if yours is cracked, broken, or missing.

Dryer door gasket seal creates an airtight barrier to prevent heat loss and improve efficiency. Replace if worn, cracked, or causing poor drying. Verify fit with your model number.

Connector assembly for dryer stack kits. Secures stacked washer and dryer units together. Replace if connector is cracked, broken, or missing hardware.

Duct assembly that channels hot air from the dryer drum to the exhaust vent. Replace if cracked, disconnected, or showing heat damage or wear.

Color: white. Measures about 12-1/2 inches wide by 11 inches high.

This genuine replacement OEM part is a motor blower assembly for dryers. The motor assembly is the main motor of the dryer that allows the dryer to spin and perform its essential functions. If the dryer is no longer turning on, spinning, or drying properly, it might be time to replace the blower motor. While this might seem like a big job, it's a relatively simple repair. To replace the blower motor assembly on the dryer, start by removing the front panel of the dryer. After removing set off the side to gain access to the back of the dryer. Locate the screws that cover the back panel at the back of the dryer drum. Remove the screws to gain access to the blower motor. Once located, remove the mounting brackets that attach the motor to the back of the dryer. Replace the old blower motor with the new, and reinstall the panels.This replacement part is sold individually by the manufacturer and is compatible with General Electric, Hotpoint, RCA, and Sears/Kenmore brand appliances.

Lock washer for dryers. Secures bolts and fasteners throughout the dryer assembly. Replace if washer is missing, damaged, or no longer grips properly.

Small metal washer used in various dryer assemblies. Replace if original is lost, worn, or damaged during repairs to ensure proper fit and spacing.

Replacement nut for dryer assembly. Secures components and panels throughout your dryer. Order a new nut if the original is stripped, missing, or damaged.

This is a hot surface glow bar igniter used in gas dryers to ignite the burner flame. It heats up until it reaches the temperature needed to open the gas valve and light the burner. Replace this part if the dryer runs but produces no heat, takes excessively long to dry clothes, or if the igniter glows but fails to ignite the gas.

Dryer door seal prevents heat loss and improves efficiency. Replace if torn, cracked, or causing poor drying performance. Confirm fit with your model.

Dryer won't heat or overheats? This thermostat assembly regulates temperature to prevent damage. Moderate DIY repair taking 30-45 minutes.

Dryer not heating or overheating? This thermostat assembly regulates temperature to ensure proper drying. Moderate difficulty repair, typically 30-45 minutes.