Parts for Ge PTDN805GM0MS: 03 - Drum, Blower & Motor Parts

Replacement drum support roller assembly for dryers. Supports and stabilizes the drum as it rotates. Replace if roller is loose, wobbly, or worn out.

Drum roller assembly for dryers. Supports and rotates the drum smoothly. Replace if worn, cracked, or causing squeaking noises during operation.

Transfers motor rotation to tumble clothes. Replace when belt shows wear, breaks, or causes slipping noise. Confirm fit with your model number.

Replacement lamp cover for your dryer's interior light. This plastic cover protects the bulb and lens. Order now if yours is cracked, broken, or missing.

Front drum bulkhead for your dryer. This structural component forms the front of the drum assembly. Replace if cracked, damaged, or worn from use.

This sensor harness connects the appliance's temperature sensor to the control board so temperature readings reach the controller reliably. It restores proper sensor communication for accurate temperature monitoring and control. What it does:

• Carries the sensor signal from the temperature probe to the main control board
• Helps prevent inaccurate temperature readings or intermittent sensor faults
• Can resolve error codes or faulty temperature readouts tied to the sensor circuit
• Replaces a damaged, burnt, or disconnected sensor wire assembly

• One sensor harness

• Disconnect power to the appliance before starting any work
• Handle connectors gently and match keyed plugs; do not force pins
• Route and secure the harness away from heat and moving parts using existing clips
• Verify connections and test appliance operation after installation

Duct assembly that channels hot air from the dryer drum to the exhaust vent. Replace if cracked, disconnected, or showing heat damage or wear.

Plastic baffle that lifts and tumbles clothes inside the dryer drum. Replace if cracked, broken, or missing to restore proper tumbling action.

Fix a dryer that won't start or hums without turning with this micro switch. Common repair for door latch and control issues. Simple installation.

Dryer mounting screw secures panels, components, or brackets. Replace if stripped, missing, or damaged during disassembly. Essential hardware part.

This is a hot surface glow bar igniter used in gas dryers to ignite the burner flame. It heats up until it reaches the temperature needed to open the gas valve and light the burner. Replace this part if the dryer runs but produces no heat, takes excessively long to dry clothes, or if the igniter glows but fails to ignite the gas.

Dryer door seal prevents heat loss and improves efficiency. Replace if torn, cracked, or causing poor drying performance. Confirm fit with your model.

Dryer won't heat or overheats? This thermostat assembly regulates temperature to prevent damage. Moderate DIY repair taking 30-45 minutes.