Parts for Ge PTDS855GM0MS: 04 - Drum, Blower & Motor Parts

Replacement drum support roller assembly for dryers. Supports and stabilizes the drum as it rotates. Replace if roller is loose, wobbly, or worn out.

Transfers motor rotation to tumble clothes. Replace when belt shows wear, breaks, or causes slipping noise. Confirm fit with your model number.

Replacement lamp cover for your dryer's interior light. This plastic cover protects the bulb and lens. Order now if yours is cracked, broken, or missing.

Front drum bulkhead for your dryer. This structural component forms the front of the drum assembly. Replace if cracked, damaged, or worn from use.

This sensor harness connects the appliance's temperature sensor to the control board so temperature readings reach the controller reliably. It restores proper sensor communication for accurate temperature monitoring and control. What it does:

• Carries the sensor signal from the temperature probe to the main control board
• Helps prevent inaccurate temperature readings or intermittent sensor faults
• Can resolve error codes or faulty temperature readouts tied to the sensor circuit
• Replaces a damaged, burnt, or disconnected sensor wire assembly

• One sensor harness

• Disconnect power to the appliance before starting any work
• Handle connectors gently and match keyed plugs; do not force pins
• Route and secure the harness away from heat and moving parts using existing clips
• Verify connections and test appliance operation after installation

Duct assembly that channels hot air from the dryer drum to the exhaust vent. Replace if cracked, disconnected, or showing heat damage or wear.

Plastic baffle that lifts and tumbles clothes inside the dryer drum. Replace if cracked, broken, or missing to restore proper tumbling action.

Fix a dryer that won't start or hums without turning with this micro switch. Common repair for door latch and control issues. Simple installation.

Dryer mounting screw secures panels, components, or brackets. Replace if stripped, missing, or damaged during disassembly. Essential hardware part.

This hot-surface oven igniter glows to ignite the gas burner, restoring reliable heat in gas ovens and ranges. Use it when a weak or failed igniter prevents the oven from reaching temperature or lighting consistently. What it does

• Heats to a high temperature to open the oven's gas valve and ignite the burner
• Replaces a cracked, brittle, or underperforming igniter that won't glow reliably
• Common symptoms: oven won't heat, long or no preheat, burner fails to light
• Matches OEM form and function for a direct replacement

• Disconnect electrical power and shut off the gas supply before servicing
• Handle the ceramic/glass element carefully; do not touch the glowing surface with bare hands
• Verify the part number on the old igniter before ordering and test for glow before reassembling

Dryer door seal prevents heat loss and improves efficiency. Replace if torn, cracked, or causing poor drying performance. Confirm fit with your model.

Dryer won't heat or overheats? This thermostat assembly regulates temperature to prevent damage. Moderate DIY repair taking 30-45 minutes.