Need Help?
Call or text
Show parts
Mounting screw kit for washers, dryers, and ranges. Replaces lost, stripped, or damaged screws used to secure panels and components during repairs.
Usually ships within 4 - 14 days
Hex washer-head screw secures dishwasher brackets, shields, and panels. Replace stripped, missing, or damaged screws to restore tight fit and stability.
Dryer shuts off too soon or won't heat? A faulty high limit thermostat often causes premature shutoff. Simple DIY fix—usually takes 15 minutes or less.
Replacement screw secures dryer panels, brackets, and internal components. Replace stripped, lost, or damaged screws to eliminate rattles and maintain assembly.
Heat deflector for dryers. Directs heated air properly through the drum. Replace if cracked, warped, or missing to restore efficient airflow distribution.
Dryer not heating consistently or overheating? This inlet thermostat monitors incoming air temperature to maintain proper heat. Restores reliable drying.
Spacer that fits on the dryer drum shaft to maintain proper spacing and alignment. Replace if worn, cracked, or missing to restore correct drum positioning.
Rear drum bearing kit supports and smoothly rotates your dryer drum. Replace when you hear squealing, screeching, or grinding noises. Verify fit with your model.
Bonds dryer cabinet to ground point for safe operation. Replace if damaged, broken, or missing to restore proper electrical grounding and reduce shock risk.
Houses and shields the burner assembly in gas dryers. Replace if cracked, warped, or damaged to restore proper flame containment and safe operation.
Transition duct connects your dryer to the wall vent exhaust system. Replace if cracked, torn, or damaged to restore proper airflow and venting.
This replacement part is a high-limit thermostat, and it is intended for use in different types of appliances. This is a genuine replacement part made by General Electric. This high-limit thermostat is typically found in dryers and controls the heat inside the drying tub. This is especially important as different dryer settings require different amounts of heat. If the high limit thermostat works properly, the temperature inside the tub should reach the correct amount during each drying cycle with no issues. A new high-limit thermostat might be needed if the user notices that the dryer is unable to reach the appropriate level of heat for a certain drying cycle. This is also true if the dryer is becoming too hot when the heat is supposed to be set to low. Make sure the dryer is cooled down prior to replacing this part as the areas in the back of the dryer can become very hot during use. Be sure to reference the specific user manual for more instructions on how to replace the thermostat. This thermostat is sold individually and is a genuine OEM part. The thermostat is sourced directly from the manufacturer.
Replaces cracked, torn, or deteriorated dryer exhaust duct hose. Connects dryer to wall vent to safely channel hot air and lint outside your home.
Secures the dryer drum to the rear bearing assembly. Replace if missing, stripped, or damaged to properly mount and stabilize the drum during operation.
Dryer won't heat after first cycle? A faulty flame sensor may not detect ignition. DIY repair with multimeter testing. Video guide included.
The bearing retainer secures the drum bearing assembly in your dryer. Replace if cracked, broken, or worn to restore proper structural support.
Supports the rear dryer drum for smooth, quiet rotation. Replace if you hear squeaking, screeching, or thumping during cycles. Verify fit with your model.
Seals the drum bearing assembly to prevent air leaks and maintain drying efficiency. Replace when worn, cracked, or if dryer is noisy. Confirm fit with model.