Edger Transmission, Brake & Clutch

This part is a replacement friction wheel assembly. This is a genuine OEM part made by MTD and has been sourced directly from the manufacturer. If the current friction wheel assembly is defective, this part can be used as a replacement. It is intended for use with a variety of snow blower models.The friction wheel assembly enables the drive wheel axle to rotate. It attaches to the friction disc itself. It's a critical component of the snow blower and thus should be immediately replaced if damaged in any way. When working on or near an engine, always ensure that the equipment is powered off and completely cooled down before attempting to undergo any repairs. For more accurate information on how and where to install this friction wheel assembly, the appropriate owner's manual and equipment diagrams should be referred to. This friction wheel assembly is suitable for use on a variety of snow blower models manufactured by MTD, Craftsman, and other brands. It is a genuine OEM part and thus is made of high-quality, durable materials. Part sold individually.

This is a gear set kit that is designed for use with many edgers for the lawn and garden. The gear set kit comes with various components that can be used as replacements when the gearbox is experiencing issues in the trimmer. In some cases, the durable metal gears can undergo wear and tear or become damaged. If the gears have worn, they may not make contact with other components, and the edger will not start or run properly. If this is occurring, the gear set kit can be used to replace the parts.A socket set and a small bearing puller are both useful for making the replacement on an edger. The blade will need to be removed, followed by the gear cover. Take out the bolt that holds the clutch hub and drive gear together. Remove these from the case and pull the bearings off. At this point, the old drive gear can be replaced with components from the kit.This kit is sold as a single unit. It is an authentic OEM replacement kit that is sourced directly from the manufacturer. The gear set kit is made to be compatible with a selection of edgers from Weed Eater and Craftsman.

This brake assembly is a genuine MTD part, sold individually. This brake assembly can be used as a replacement part in lawnmowers, string trimmers, and edgers. This assembly contains all of the parts needed to replace the brakes in one of these pieces of equipment.If the brake is slow to respond or does not respond to user input at all, the brake assembly should be ordered as a genuine OEM replacement part. Refer to the manual for proper installation instructions.Sourced directly from the manufacturer, this component is a genuine replacement part that is sold individually. This brake assembly is compatible with the following outdoor appliance brands: MTD, Cub Cadet, and Craftsman.